MAX9714 Maxim Integrated Products, Inc., MAX9714 Datasheet
MAX9714
Available stocks
Related parts for MAX9714
MAX9714 Summary of contents
Page 1
... The MAX9713 is available in a 32-pin TQFN (5mm x 5mm x 0.8mm) package. The MAX9714 is available in a 32-pin TQFN (7mm x 7mm x 0.8mm) package. Both devices are specified over the extended -40°C to +85° ...
Page 2
... Continuous Power Dissipation (T Single-Layer Board: + 0.3V) MAX9713 32-Pin TQFN (derate 21.3mW/°C DD above +70°C)..........................................................1702.1mW - 0.3V) to +40V MAX9714 32-Pin TQFN (derate 27mW/°C DD above +70°C)..........................................................2162.2mW Multilayer Board: MAX9713 32-Pin TQFN (derate 34.5mW/°C above +70°C)..........................................................2758.6mW MAX9714 32-Pin TQFN (derate 37mW/°C above +70° ...
Page 3
ELECTRICAL CHARACTERISTICS (continued) = 15V, GND = PGND = 0V, SHDN ≥ GND (f = 330kHz), R connected between OUTL+ and OUTL- and OUTR+ and OUTR Typical values are +25°C.) (Notes ...
Page 4
Filterless, Spread-Spectrum Mono/Stereo Class D Amplifiers (136µH with 16Ω, 68µH with 8Ω, part in SSM mode, unless otherwise noted.) TOTAL HARMONIC DISTORTION PLUS NOISE vs. FREQUENCY +15V 13dB 8Ω L ...
Page 5
SSM mode, unless otherwise noted.) TOTAL HARMONIC DISTORTION PLUS NOISE vs. OUTPUT POWER 100 V = 15V 13dB 1kHz 8Ω SSM ...
Page 6
... SSM MODE OUT 1kHz R = 8Ω L -20 A-WEIGHTED RBW = 10kHz -40 -60 -80 -100 -120 0 5k 10k 15k FREQUENCY (Hz) TURN-ON/TURN-OFF RESPONSE C = 180pF SS SHDN MAX9714 OUTPUT f = 1kHz R = 8Ω L 10M 100M 0.35 0.30 0.25 0.20 0.15 0.10 0. WIDEBAND OUTPUT SPECTRUM (FFM MODE) 0 -10 -20 -30 ...
Page 7
... PIN NAME MAX9713 MAX9714 23, 24 PGND C1N 6 6 C1P 7 7 CHOLD 8, 17, 20, 25, 8 N.C. 26, 31 REG 10 13 AGND 11 — 12 — IN SHDN FS1 19 20 FS2 27, 28 — OUT- 29, 30 — ...
Page 8
... This can be done at any time and not affect audio reproduction OUT- OUT+ Figure 1. MAX9714 Outputs with No Input Signal Applied 8 _______________________________________________________________________________________ Table 1. Operating Modes FS1 FS2 ...
Page 9
... PWM scheme uses large differential output swings (2 currents. Any parasitic resistance in the filter compo- nents results in a loss of power, lowering the efficiency. The MAX9713/MAX9714 do not require an output filter. SS The devices rely on the inherent inductance of the speaker coil and the natural filtering of both the speak- ...
Page 10
... The signals appear at the amplifiers’ inputs as common- mode noise. A differential input amplifier amplifies the difference of the two inputs, any signal common to both inputs is canceled. The MAX9713/MAX9714 can be configured as single- ended input amplifiers by capacitively coupling either Gain Selection input to GND and driving the other input (Figure 5). ...
Page 11
... PGND with a 0.1µF capacitor as close to each V as possible. A low-impedance, high-current power-sup- ply connection to V capacitance should be added as required depending on the application and power-supply characteristics. AGND and PGND should be star connected to system ground. Refer to the MAX9714 Evaluation Kit for layout guidance OUTR ...
Page 12
Filterless, Spread-Spectrum Mono/Stereo Class D Amplifiers 0.47µF 0.47µF V REG V REG V REG V REG V REG 0.18µF 10V 0.01µF 10V LOGIC INPUTS SHOWN FOR A †CHOOSE A CAPACITOR VOLTAGE RATING ≥ V *SYSTEM-LEVEL REQUIREMENT. 12 ______________________________________________________________________________________ 10V ...
Page 13
... REQUIREMENT. ______________________________________________________________________________________ Functional Diagrams (continued) 10V TO +25V 0.1µF 25V† PGND DD DD OUTL+ 32 OUTL+ 31 H-BRIDGE OUTL- 30 OUTL- 29 OUTR+ 28 OUTR+ 27 H-BRIDGE OUTR- 26 OUTR- 25 MAX9714 6 C1P C1 CHARGE PUMP 0.1µF 5 25V† C1N CHOLD 7 C2 1µF 25V† ...
Page 14
... Mono/Stereo Class D Amplifiers OUTL- OUTL+ CODEC OUTR+ OUTR- 1µF 1µF 1µF *SYSTEM-LEVEL REQUIREMENT. 14 ______________________________________________________________________________________ V DD 100µ 0.47µF INL- 0.47µF INL+ MAX9714 0.47µF INR+ 0.47µF INR- SS 0.18µF SHDN 1µ INL- 15kΩ MAX9722B OUTL INL+ 15kΩ OUTR INR ...
Page 15
For the latest package outline information www.maxim-ic.com/packages.) E E/2 D/2 D ______________________________________________________________________________________ 6W, Filterless, Spread-Spectrum Mono/Stereo Class D Amplifiers DETAIL A e (ND-1) X ...
Page 16
Filterless, Spread-Spectrum Mono/Stereo Class D Amplifiers (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages.) 16 ______________________________________________________________________________________ Package Information (continued) PACKAGE OUTLINE 32, 44, 48, ...
Page 17
For the latest package outline information www.maxim-ic.com/packages.) ______________________________________________________________________________________ 6W, Filterless, Spread-Spectrum Mono/Stereo Class D Amplifiers Package Information (continued) PACKAGE OUTLINE, 16, 20, 28, 32, ...
Page 18
... Maxim reserves the right to change the circuitry and specifications without notice at any time. 18 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © 2006 Maxim Integrated Products Package Information (continued) PACKAGE OUTLINE, 16, 20, 28, 32, 40L THIN QFN, 5x5x0.8mm 21-0140 is a registered trademark of Maxim Integrated Products, Inc ...