WM8734 ETC-unknow, WM8734 Datasheet - Page 24

no-image

WM8734

Manufacturer Part Number
WM8734
Description
Stereo Audio Codec
Manufacturer
ETC-unknow
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
WM8734EDS/R
Manufacturer:
WOLFSON
Quantity:
20 000
Part Number:
WM8734SEFL/R
Manufacturer:
ON
Quantity:
3 000
Part Number:
WM8734SEFL/R
Manufacturer:
WOLFSON
Quantity:
20 000
WM8734
w
Uniquely, the WM8734 offers the user the ability to sample the ADC and DAC at different rates under
software control in both Normal and USB modes. The reduces the burden on any controlling DSP.
However, the signal processing in the ADC and DAC over-sampling filters is tightly coupled together
in order to minimise power consumption. To this end, only the combinations of sample rates listed in
the following sections are supported. Note that these rates supported are anticipated to be the likely
combinations used in typical audio systems.
Table 9 Sample Rate Control
SAMPLE RATE SETTING
In normal mode MCLK/crystal oscillator is set up according to the desired sample rates of the ADC
and DAC. For ADC or DAC sampling rates of 8, 32, 48 or 96KHz, MCLK frequencies of either
12.288MHz (256fs) or 18.432MHz (384fs) can be used. For ADC or DAC sampling rates of 8, 44.1 or
88.2KHz from MCLK frequencies of either 11.2896MHz (256fs) or 16.9344MHz (384fs) can be used.
The table below should be used to set up the device to work with the various sample rate
combinations. For example if the user wishes to use the WM8734 in normal mode with the ADC and
DAC sample rates at 48KHz and 48KHz respectively then the device should be programmed with
BOSR = 0, SR3 = 0, SR2 = 0, SR1 = 0 and SR0 = 0 with a 12.288MHz MCLK or with BOSR = 1,
SR3 = 0, SR2 = 0, SR1 = 0 and SR0 = 0 with a 18.432MHz MCLK. The ADC and DAC will then
operate with a Digital Filter of type 1, refer to Digital Filter Characteristics section for an explanation
of the different filter types.
0001000
Sampling
Control
REGISTER
ADDRESS
0
1
5:2
BIT
USB/
NORMAL
BOSR
SR[3:0]
LABEL
0
0
0000
DEFAULT
Mode Select
1 = USB mode (250/272fs)
0 = Normal mode (256/384fs)
Base Over-Sampling Rate
USB Mode
0 = 250fs
1 = 272fs
ADC and DAC sample rate control;
See USB Mode and Normal Mode
Sample Rate sections for operation
DESCRIPTION
AI Rev 2.2 November 2001
Advanced Information
Normal Mode
0 = 256fs
1 = 384fs
24

Related parts for WM8734