RS5C348A RICOH Co.,Ltd., RS5C348A Datasheet - Page 31

• Manufacturer Part Number: RS5C348A
• Description: 4-wire Serial Interface Real-time Clock
• Manufacturer: RICOH Co.,Ltd.

Rev.2.01
The oscillator adjustment circuit is configured to change time counts of 1 second on the basis of the settings of
the oscillation adjustment register once in 20 seconds or 60 seconds. The oscillation adjustment circuit does
not effect the frequency of 32768Hz-clock pulse output from the 32KOUT pin. Therefore, after writing the
oscillation adjustment register, we cannot measure the clock error with probing 32KOUT clock pulses. The way
to measure the clock error as follows:
(1) Output a 1Hz clock pulse of Pulse Mode with interrupt pin
Set (0,0,x,x,0,0,1,1) to Control Register 1 at address Eh.
(2) After setting the oscillation adjustment register, 1Hz clock period changes every 20seconds ( or every 60
seconds) like next page figure.
Measure the interval of T0 and T1 with frequency counter. A frequency counter with 7 or more digits is
recommended for the measurement.
(3) Calculate the typical period from T0 and T1
T = (19×T0+1×T1)/20
Calculate the time error from T.
1Hz clock pulse
How to evaluate the clock gain or loss
Notes:
1)
2)
For more details, please contact to Ricoh.
1. Using oscillator adjustment function
2. Access to Rx5C348A/B at random, or synchronized with external clock that has no relation to
3. Access to Rx5C348A/B more than 2 times per each second on average.
Oscillation adjustment does not affect the frequency of 32.768-kHz clock pulses output from the
32KOUT pin.
If following 3 conditions are completed, actual clock adjustment value could be different from target
adjustment value that set by oscillator adjustment function.
Rx5C348A/B, or synchronized with periodic interrupt in pulse mode.
T0
T0
19 times
- 31 -
T0
1 time
T1
12345
Rx5C348A/B