LT1353 Linear Technology Corporation, LT1353 Datasheet - Page 9

• Manufacturer Part Number: LT1353
• Description: Dual And Quad 250ua, 3mhz, 200v/us Operational Amplifier
• Manufacturer: Linear Technology Corporation

APPLICATIONS
TYPICAL PERFORMANCE CHARACTERISTICS
Layout and Passive Components
The LT1352/LT1353 amplifiers are easy to use and toler-
ant of less than ideal layouts. For maximum performance
(for example, fast 0.01% settling) use a ground plane,
short lead lengths and RF-quality bypass capacitors (0.01 F
to 0.1 F). For high drive current applications use low ESR
bypass capacitors (1 F to 10 F tantalum).
The parallel combination of the feedback resistor and
gain setting resistor on the inverting input can combine
with the input capacitance to form a pole which can cause
peaking or even oscillations. If feedback resistors greater
than 10k are used, a parallel capacitor of value, C
(R
optimize dynamic performance. For applications where
the DC noise gain is one and a large feedback resistor is
used, C
example would be an I-to-V converter as shown in the
Typical Applications section.
G
)(C
Small-Signal Transient
(A
Large-Signal Transient
(A
IN
V
V
F
= 1)
= 1)
/R
should be greater than or equal to C
F
), should be used to cancel the input pole and
U
INFORMATION
U
W
1352/53 G31
1352/53 G34
U
W
Small-Signal Transient
(A
Large-Signal Transient
(A
V
V
U
= – 1)
= – 1)
IN
. An
F
>
Capacitive Loading
The LT1352/LT1353 are stable with any capacitive load.
As the capacitive load increases, both the bandwidth and
phase margin decrease so there will be peaking in the
frequency domain and in the transient response. Graphs
of Frequency Response vs Capacitive Load, Capacitive
Load Handling and the transient response photos clearly
show these effects.
Input Considerations
Each of the LT1352/LT1353 inputs is the base of an NPN
and a PNP transistor whose base currents are of opposite
polarity and provide first-order bias current cancellation.
Because of variation in the matching of NPN and PNP beta,
the polarity of the input bias current can be positive or
negative. The offset current does not depend on NPN/PNP
beta matching and is well controlled. The use of balanced
source resistance at each input is recommended for
1352/53 G32
1352/53 G35
Small-Signal Transient
(A
Large-Signal Transient
(A
V
V
= – 1, C
= 1, C
LT1352/LT1353
L
L
= 10,000pF)
= 1000pF)
1352/53 G33
1352/53 G36
13523fa
9