RL1024P Perkin Elmer Optoelectronics, RL1024P Datasheet - Page 40

• Manufacturer Part Number: RL1024P
• Manufacturer: Perkin Elmer Optoelectronics

38
cooled ccd sensors
www.optoelectronics.perkinelmer.com
Features
• 363,000 picture elements (pixels)
• 24 µm square pixels
• 2-phase buried channel process
• On-chip amplifier for low noise
• Dynamic range greater than
• On-chip temperature sensor
• Two-stage TE cooler integrated
• Hermetically sealed
• 100% fill factor
• 10MHz data rate
Typical Applications
• Spectroscopy
• Fluorescence Microscopy
• Luminescence
• Protein Quantification
Datasheet available upon request
in a 1100x330 configuration
and high-speed readout
25,000:1
into the package
Dynamic Range:
Full Well Charge:
Dark Current MPP:
Read Noise:
Absolute Maximum Ratings
Storage Temperature:
Operating Temperature:
Description
The RA1133J is a full-frame CCD sensor with reset capabilities
designed specifically for use in spectroscopy, biomedical imaging
and related scientific imaging applications. The package for the
array is designed with an integrated two-stage thermoelectric
cooler. This enables the device to be run 40°C below ambient
temperature, -15°C when compared to room temperature. Its
combination of very low noise and low dark current make
the RA1133J ideal for low-light, high dynamic range, and high-
resolution applications.
The imager is structured with a single-output register at one
end of the imaging columns. A lateral reset drain is located
adjacent to this readout register, which enables the dumping
of accumulated charge from the array. Two-phase clocks are
needed to drive the readout register, and three-phase clocks are
needed to drive imaging cells. The array is available in a 30-pin
metal package with an integrated TE cooler.
Photo Response Non Uniformity
General Characteristics
Charge Transfer Efficiency
Dark Signal Uniformity
Output Amplifier Gain
Operating Frequency
Saturation Voltage
Dark Current MPP
Full Well Charge
Dynamic Range
Imaging Area
Read Noise
Parameter
Pixel Size
Format
Full well/read noise, MPP mode
RLoad = 5.1 k , MPP mode
MPP mode at -15˚C
Measured at 500 kHz at -15˚C
Symbol
PRNU
DSNU
fclock
Q
V
CTE
DR
DL
SAT
SAT
-55°C min. to 85°C max.
0°C min. to 55°C max.
>0.9999
1000
Min.
250
Table of Contents
1100x330
26.4x7.92
>0.99995
25,000:1
24x24
1200
Typ.
300
10
1
5
2
4
Max.
10
10
3
5
pA/cm2
µV/e-
MHz
Units
mm
µm
Ke-
mV
±%
±%
e-