ADDAC80 Analog Devices, ADDAC80 Datasheet - Page 14

• Manufacturer Part Number: ADDAC80
• Description: Complete Low Cost Hybrid 12-Bit D/A Converter 0 to +70 C
• Manufacturer: Analog Devices

ADDAC80/ADDAC85/ADDAC87
0.225 (5.72)
NOTES
1. INDEX AREA; A NOTCH OR A LEAD ONE IDENTIFICATION MARK IS LOCATED ADJACENT TO LEAD ONE.
2. THE MINIMUM LIMIT FOR DIMENSION MAY BE 0.023" (0.58 mm) FOR ALL FOUR CORNER LEADS ONLY.
3. DIMENSION SHALL BE MEASURED FROM THE SEATING PLANE TO THE BASE PLANE.
4. THE BASIC PIN SPACING IS 0.100" (2.54 mm) BETWEEN CENTERLINES.
5. APPLIES TO ALL FOUR CORNERS.
6. SHALL BE MEASURED AT THE CENTERLINE OF THE LEADS.
7. TWENTY TWO SPACES.
8. CONTROLLING DIMENSIONS ARE IN MILLIMETERS: INCH DIMENSIONS ARE ROUNDED-OFF MILLIMETER
SEE NOTE 1
0.200 (5.08)
0.120 (3.05)
EQUIVALENTS FOR REFERENCE ONLY AND ARE NOT APPROPRIATE FOR USE IN DESIGN.
PIN 1
MAX
0.005 (0.13) MIN
0.023 (0.58)
0.014 (0.36)
24-Lead Side Brazed Ceramic DIP for Hybrid (DH-24A)
24
1
1.212 (29.69) MAX
SEE NOTE 4, 7
0.100 (2.54)
SEE NOTE 5
BSC
Dimensions shown in inches and (mm).
OUTLINE DIMENSIONS
0.098 (2.49) MAX
0.070 (1.78)
0.030 (0.76)
SEE NOTE 2
12
13
0.075 (1.91)
0.015 (0.38)
SEE NOTE 3
SEATING
PLANE
0.180
(4.57)
MIN
0.600 (14.70)
0.580 (14.21)
0.620 (15.75)
0.590 (14.99)
SEE NOTE 6
0.015 (0.38)
0.008 (0.20)