MODEL232BSS4 B&B Electronics, MODEL232BSS4 Datasheet - Page 30

• Manufacturer Part Number: MODEL232BSS4
• Description: Buffered Smart Switch
• Manufacturer: B&B Electronics

Copying Parameters Between Switches:
parameters:
28
Once the configuration file has been loaded, any number of
switches can be set to the same parameters by connecting and
configuring each in turn.
Default Parameters:
Auto Select mode OFF
DTR NOT required to accept commands
THREE-character command
Char1 = ESC (Decimal 27)
Char2 = STX (Decimal 2)
Char3 = “0” (Not Used)
Port Time = 1,000 mS (Not Used)
Inactivity Time = 500 mS (Not Used)
All ports 9600 Baud
All ports 8 Data Bits
All ports No Parity
All ports No Hardware Handshake required
Ports A-D No preamble
Port A selected to Transmit & Receive on Power-up
The 232BSS4 setup software can save configuration data to a
file for copying of parameters. Any unit’s setup can be copied by
first reading the data from one switch, then saving to another.
Step 1: Run the setup software.
Step 2: Select serial (COM) port to be used for programming.
Step 3: Select Single Unit operation. If the configuration to be
Step 4: Connect the switch to be copied to the serial (COM)
Step 5: Click Next.
Step 6: Select Save As from the File menu. Save the
Step 7: Disconnect the first 232BSS4 from the COM port.
Step 8: Connect the destination switch to the serial (COM) port
Step 9: Select File/Load File and load the saved configuration.
Step 10: Click Save Changes
When shipped, the 232BSS4 comes set up for the following
used is already saved to a file, skip to Step 8.
port of the PC. Install the setup jumper. Apply power to
the 232BSS4.
configuration to disk.
of the PC. Install the setup jumper. Apply power to the
232BSS4.
Documentation Number 232BSS41202 Manual