AT93C56A-10SE-2.7 ATMEL Corporation, AT93C56A-10SE-2.7 Datasheet - Page 2

• Manufacturer Part Number: AT93C56A-10SE-2.7
• Description: 3-wire Serial EEPROMs 2K (256 x 8 or 128 x 16)
• Manufacturer: ATMEL Corporation

Absolute Maximum Ratings*
Block Diagram
2
Operating Temperature
Storage Temperature
Voltage on Any Pin
with Respect to Ground
Maximum Operating Voltage .......................................... 6.25V
DC Output Current........................................................ 5.0 mA
The AT93C56A/66A is enabled through the Chip Select pin (CS) and accessed via a
3-wire serial interface consisting of Data Input (DI), Data Output (DO), and Shift Clock
(SK). Upon receiving a READ instruction at DI, the address is decoded and the data is
clocked out serially on the data output pin DO. The WRITE cycle is completely self-
timed and no separate ERASE cycle is required before WRITE. The WRITE cycle is
only enabled when the part is in the ERASE/WRITE ENABLE state. When CS is brought
“high” following the initiation of a WRITE cycle, the DO pin outputs the READY/BUSY
status of the part.
The AT93C56A/66A is available in 2.7V to 5.5V and 1.8V to 5.5V versions.
Note:
55 C to +125 C
65 C to +150 C
When the ORG pin is connected to VCC, the x 16 organization is selected. When it is
connected to ground, the x 8 organization is selected. If the ORG pin is left unconnected
and the application does not load the input beyond the capability of the internal 1 Meg
ohm pullup, then the x 16 organization is selected. The feature is not available on the
1.8V devices.
1.0V to +7.0V
*NOTICE:
Stresses beyond those listed under “Absolute
Maximum Ratings” may cause permanent dam-
age to the device. This is a stress rating only, and
functional operation of the device at these or any
other conditions beyond those indicated in the
operational sections of this specification is not
implied. Exposure to absolute maximum rating
conditions for extended periods may affect
device reliability
3378F–SEEPR–04/04