PIC16C773 Microchip Technology, PIC16C773 Datasheet - Page 74

no-image

PIC16C773

Manufacturer Part Number
PIC16C773
Description
28/40-Pin/ 8-Bit CMOS Microcontrollers w/ 12-Bit A/D
Manufacturer
Microchip Technology
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
PIC16C773-E/SS
Quantity:
7
Part Number:
PIC16C773-I/SO
Quantity:
11
Part Number:
PIC16C773-I/SO
Manufacturer:
MICROCHIP/微芯
Quantity:
20 000
Company:
Part Number:
PIC16C773-I/SO
Quantity:
8 700
Part Number:
PIC16C773/JW
Manufacturer:
Microchip
Quantity:
6
Part Number:
PIC16C773/SO
Manufacturer:
Microchip Technology
Quantity:
135
Part Number:
PIC16C773/SO
Manufacturer:
MICROCHIP/微芯
Quantity:
20 000
PIC16C77X
8.2.9
To initiate a START condition, the user sets the start
condition enable bit, SEN (SSPCON2<0>). If the SDA
and SCL pins are sampled high, the baud rate genera-
tor is re-loaded with the contents of SSPADD<6:0>,
and starts its count. If SCL and SDA are both sampled
high when the baud rate generator times out (T
the SDA pin is driven low. The action of the SDA being
driven low while SCL is high is the START condition,
and causes the S bit (SSPSTAT<3>) to be set. Follow-
ing this, the baud rate generator is reloaded with the
contents of SSPADD<6:0> and resumes its count.
When the baud rate generator times out (T
SEN bit (SSPCON2<0>) will be automatically cleared
by hardware, the baud rate generator is suspended
leaving the SDA line held low, and the START condition
is complete.
FIGURE 8-20: FIRST START BIT TIMING
DS30275A-page 74
Note:
I
TIMING
2
C MASTER MODE START CONDITION
If at the beginning of START condition the
SDA and SCL pins are already sampled
low, or if during the START condition the
SCL line is sampled low before the SDA
line is driven low, a bus collision occurs, the
Bus Collision Interrupt Flag (BCLIF) is set,
the START condition is aborted, and the
I
2
C module is reset into its IDLE state.
Write to SEN bit occurs here.
SDA
SCL
Advance Information
BRG
SDA = 1,
SCL = 1
T
), the
BRG
BRG
),
Set S bit (SSPSTAT<3>)
S
T
BRG
At completion of start bit,
Hardware clears SEN bit
8.2.9.5
If the user writes the SSPBUF when an START
sequence is in progress, then WCOL is set and the
contents of the buffer are unchanged (the write doesn’t
occur).
and sets SSPIF bit
Note:
T
Write to SSPBUF occurs here
BRG
1st Bit
WCOL STATUS FLAG
Because queueing of events is not
allowed, writing to the lower 5 bits of
SSPCON2 is disabled until the START
condition is complete.
T
BRG
1999 Microchip Technology Inc.
2nd Bit

Related parts for PIC16C773