ISL6208 Intersil Corporation, ISL6208 Datasheet - Page 8

• Manufacturer Part Number: ISL6208
• Description: High Voltage Synchronous Rectified Buck MOSFET Driver
• Manufacturer: Intersil Corporation

Layout Considerations
Reducing Phase Ring
The parasitic inductances of the PCB and power devices
(both upper and lower FETs) could cause increased PHASE
ringing, which may lead to voltages that exceed the absolute
maximum rating of the devices. When PHASE rings below
ground, the negative voltage could add charge to the
bootstrap capacitor through the internal bootstrap diode.
Under worst-case conditions, the added charge could
overstress the BOOT and/or PHASE pins. To prevent this
from happening, the user should perform a careful layout
inspection to reduce trace inductances, and select low lead
inductance MOSFETs and drivers. D
packaged MOSFETs have high parasitic lead inductances,
as opposed to SOIC-8. If higher inductance MOSFETs must
be used, a Schottky diode is recommended across the lower
MOSFET to clamp negative PHASE ring.
A good layout would help reduce the ringing on the phase
and gate nodes significantly:
• Avoid using vias for decoupling components where
• All power traces (UGATE, PHASE, LGATE, GND, VCC)
• Keep the SOURCE of the upper FET as close as thermally
• Keep the connection in between the SOURCE of lower
• Input capacitors should be placed as close to the DRAIN
Note: Refer to Intersil Tech Brief TB447 for more information.
Thermal Management
For maximum thermal performance in high current, high
switching frequency applications, connecting the thermal
pad of the QFN part to the power ground with multiple vias,
or placing a low noise copper plane underneath the SOIC
part is recommended. This heat spreading allows the part to
achieve its full thermal potential.
possible, especially in the BOOT-to-PHASE path. Little or
no use of vias for VCC and GND is also recommended.
Decoupling loops should be short.
should be short and wide, and avoid using vias. If vias
must be used, two or more vias per layer transition is
recommended.
possible to the DRAIN of the lower FET.
FET and power ground wide and short.
of the upper FET and the SOURCE of the lower FET as
thermally possible.
8
2
PAK and DPAK
ISL6208
March 30, 2007
FN9115.2