SA25F005 Saifun, SA25F005 Datasheet - Page 25

• Manufacturer Part Number: SA25F005
• Description: 512Kb Serial Flash
• Manufacturer: Saifun

Page Programming (PP)
The PP instruction allows bytes to be
programmed in the memory (changing bits
from 1 to 0). In order to program to the
SA25F005, two separate instructions must
be executed. The device must first be write
enabled via the WREN instruction, and
then a PP sequence (which consists of four
bytes plus data) may be executed. The
address of the memory locations to be
written must be outside the protected
address field location selected by the Block
Write Protection level. During an internal
Program cycle, all commands are ignored
except the RDSR instruction.
A PP instruction requires the following
sequence:
Programming starts after the CSb pin is
brought high. The CSb pin's low-to-high
transition must occur during the SCK low
time, immediately after the clock in the D0
(LSB) data bit. The instruction sequence is
shown in Figure 16, page 26.
= After the CSb line is pulled low to
select the device, the PP opcode is
transmitted via the SI line, followed
by the byte address and the data
(D7-D0) to be written.
As soon as CSb is driven high, the
self-timed PP cycle (whose duration is
defined as T
Program cycle is in progress, the status
register may be read to check the value of
the Write in Progress (/RDY) bit. The /RDY
bit is 1 during the self-timed Page Program
cycle, and 0 when it is completed. The
Write Enable Latch (WEN) bit is reset at
some unspecified time before the cycle is
completed.
The SA25F005's PP operation is capable
of up to a 256-byte programming, from 1 to
256 bytes at a time (changing bits from 1 to
0), provided that they lie in consecutive
addresses on the same page of memory.
After each byte is received, the eight
low-order
incremented by one. If more than 256
bytes of data are transmitted, the address
counter rolls over and the previously
written data is overwritten. The SA25F005
is automatically returned to the write
disable state at the completion of a Write
cycle.
NOTES:
1. If the device is not write enabled,
2. A PP instruction applied to a page
the
instruction
standby state when CSb is brought
high. A new CSb falling edge is
required to re-initiate the serial
communication.
that is protected by the Block
Protect
described in Table 8, page 18, and
Table 9, page 21) is not executed.
address
PP
device
) is initiated. While the Page
(BP1,
SA25F005 Advanced Information
and
ignores
bits
BP0)
returns
www.DataSheet4U.com
are
bits
the
to
internally
SAIFUN
the
(as
PP
25