MIC4720 Micrel Semiconductor, MIC4720 Datasheet - Page 18

• Manufacturer Part Number: MIC4720
• Description: 2A Integrated Switch Buck Regulator
• Manufacturer: Micrel Semiconductor

Ripple measurements
To properly measure ripple on either input or output of a
switching regulator, a proper ring in tip measurement is
required. Standard oscilloscope probes come with a
grounding clip, or a long wire with an alligator clip.
Unfortunately, for high frequency measurements, this
ground clip can pick-up high frequency noise and
erroneously inject it into the measured output ripple.
The standard evaluation board accommodates a home
made version by providing probe points for both the
input and output supplies and their respective grounds.
This requires the removing of the oscilloscope probe
sheath and ground clip from a standard oscilloscope
probe and wrapping a non-shielded bus wire around the
oscilloscope probe. If there does not happen to be any
non shielded bus wire immediately available, the leads
from axial resistors will work.
shortest possible ground lengths on the oscilloscope
probe, true ripple measurements can be obtained.
Micrel, Inc.
May 2007
By maintaining the
18
M9999-051707
MIC4720