ADP5023CP-EVALZ Analog Devices, Inc., ADP5023CP-EVALZ Datasheet - Page 20

• Manufacturer Part Number: ADP5023CP-EVALZ
• Description: Dual 3 Mhz, 800 Ma Buck Regulators With One 300 Ma Ldo
• Manufacturer: Analog Devices, Inc.

ADP5023
the input conditions change again and the required duty cycle
falls, the buck immediately restarts PWM regulation without
allowing overshoot on the output voltage.
Active Pull-Downs
All regulators have optional, factory-programmable, active pull-
down resistors discharging the respective output capacitors
when the regulators are disabled. The pull-down resistors are
connected between VOUTx and AGND. Active pull-downs are
disabled when the regulators are turned on. The typical value of
the pull-down resistor is 600 Ω for the LDO and 75 Ω for the
bucks. Figure 46 shows the activation timings for the active
pull-downs during regulator activation and deactivation.
LDO
The
and low dropout voltage, and provides up to 300 mA of output
current. Drawing a low 10 μA quiescent current (typical) at no
load makes the LDO ideal for battery-operated portable
equipment.
The LDO operates with an input voltage of 1.7 V to 5.5 V. The
wide operating range makes these LDO suitable for cascading
ADP5023
contains one LDO with low quiescent current
Rev. 0 | Page 20 of 28
configurations where the LDO supply voltage is provided from
one of the buck regulators.
The LDO output voltage is set through external resistor dividers
as shown in Figure 48 for LDO. The output voltage can
optionally be factory programmed to default values as indicated
in the Ordering Guide section. In this event, Ra and Rb are not
needed, and FB3 can be left unconnected. FB3 is 0.5 V.
The LDO also provides high power supply rejection ratio
(PSRR), low output noise, and excellent line and load transient
response with only a small 1 μF ceramic input and output
capacitor.
VIN3
V
OUT3
Figure 48. LDO External Output Voltage Setting
= V
FB3
LDO1
Ra
Rb
+ 1
VOUT3
FB3
Ra
Rb
C7
1µF
Data Sheet
VOUT3