LTC2487 Linear Technology, LTC2487 Datasheet - Page 23

• Manufacturer Part Number: LTC2487
• Description: 16-Bit 2-/4-Channel ADC
• Manufacturer: Linear Technology

www.DataSheet4U.com
applicaTions inForMaTion
For many applications, the sensor output impedance
combined with external input bypass capacitors produces
RC time constants much greater than the 580ns required
for 1ppm accuracy. For example, a 10kW bridge driving a
0.1µF capacitor has a time constant an order of magnitude
greater than the required maximum.
The LTC2487 uses a proprietary switching algorithm
that forces the average differential input current to zero
independent of external settling errors. This allows direct
digitization of high impedance sensors without the need
for buffers.
The switching algorithm forces the average input current
on the positive input (I
current on the negative input (I
conversion cycle, the average differential input current
(I
zero, the common mode input current (I
proportional to the difference between the common mode
input voltage (V
voltage (V
In applications where the input common mode voltage is
equal to the reference common mode voltage, as in the
case of a balanced bridge, both the differential and com-
mon mode input current are zero. The accuracy of the
converter is not compromised by settling errors.
In applications where the input common mode voltage is
constant but different from the reference common mode
voltage, the differential input current remains zero while
the common mode input current is proportional to the
difference between V
common mode voltage of 2.5V and an input common mode
of 1.5V, the common mode input current is approximately
0.74µA (in simultaneous 50Hz/60Hz rejection mode). This
IN
+
– I
IN
–
REF(CM)
) is zero. While the differential input current is
IN(CM)
).
IN(CM)
) and the common mode reference
IN
+
) to be equal to the average input
and V
IN
REF(CM)
–
). Over the complete
. For a reference
IN
+
+ I
IN
–
)/2 is
common mode input current does not degrade the accuracy
if the source impedances tied to IN
Mismatches in source impedance lead to a fixed offset
error but do not effect the linearity or full-scale reading.
A 1% mismatch in a 1k source resistance leads to a 74µV
shift in offset voltage.
In applications where the common mode input voltage
varies as a function of the input signal level (single-ended
type sensors), the common mode input current varies
proportionally with input voltage. For the case of balanced
input impedances, the common mode input current effects
are rejected by the large CMRR of the LTC2487, leading
to little degradation in accuracy. Mismatches in source
impedances lead to gain errors proportional to the dif-
ference between the common mode input and common
mode reference. A 1% mismatch in 1k source resistances
lead to gain errors on the order of 15ppm. Based on the
stability of the internal sampling capacitors and the ac-
curacy of the internal oscillator, a one-time calibration will
remove this error.
In addition to the input sampling current, the input ESD
protection diodes have a temperature dependent leakage
current. This current, nominally 1nA (±10nA max), results
in a small offset shift. A 1k source resistance will create a
1µV typical and a 10µV maximum offset voltage.
Reference Current
Similar to the analog inputs, the LTC2487 samples the
differential reference pins (REF
small amounts of charge to and from these pins, thus
producing a dynamic reference current. If incomplete set-
tling occurs (as a function the reference source resistance
and reference bypass capacitance) linearity and gain errors
are introduced.
+
and REF
+
and IN
LTC2487
–
–
) transferring
are matched.

2487fa