ltc3862gn-1 Linear Technology Corporation, ltc3862gn-1 Datasheet - Page 28

• Manufacturer Part Number: ltc3862gn-1
• Description: Multi-phase Current Mode Step-up Dc/dc Controller
• Manufacturer: Linear Technology Corporation

LTC3862-1
APPLICATIONS INFORMATION
For a boost converter where the current limit value is
chosen to be 30% higher than the maximum load current,
the peak current in the MOSFET and sense resistor is:
The sense resistor value is then:
Again, the factor n is the number of phases used, and χ
represents the percentage ripple current in the inductor.
The number 1.3 represents the factor by which the cur-
rent limit exceeds the maximum load current, I
For example, if the current limit needs to exceed the
maximum load current by 50%, then the 1.3 factor should
be replaced with 1.5.
The average power dissipated in the sense resistor can
easily be calculated as:
This equation assumes no temperature coeffi cient for
the sense resistor. If the resistor chosen has a signifi cant
temperature coeffi cient, then substitute the worst-case
high resistance value into the equation.
28
I
R
P
SW(MAX)
R(SENSE)
SENSE
=
=I
=
V
SENSE(MAX)
R(SENSE)
1.3 • 1+
n • 1– D
1.3 •I
(
O(MAX)
=
MAX
n
1
• n • 1– D
2
• 1+
Figure 21. Diode Current Waveform for a High Duty Cycle Application
)
•I
(
O(MAX)
2
INDUCTOR
• R
SW NODE
CURRENT
CURRENT
2
50V/DIV
1A/DIV
1A/DIV
MAX
DIODE
SENSE
•
1.3 •I
)
1– D
V
V
IN
OUT
• D
= 12V
= 72V
O(MAX)
MAX
MAX
O(MAX)
.
1μs/DIV
The resistor temperature can be calculated using the
equation:
Selecting the Output Diodes
To maximize effi ciency, a fast switching diode with low
forward drop and low reverse leakage is required. The
output diode in a boost converter conducts current during
the switch off-time. The peak reverse voltage that the diode
must withstand is equal to the regulator output voltage.
The average forward current in normal operation is equal
to the output current, and the peak current is equal to the
peak inductor current:
Although the average diode current is equal to the output
current, in very high duty cycle applications (low V
high V
higher than the average, as shown in Figure 21. In this
case check the diode manufacturer’s data sheet to ensure
that its peak current rating exceeds the peak current in
the equation above. In addition, when calculating the
power dissipation in the diode, use the value of the
forward voltage (V
the average output current. Excess power will be dissi-
pated in the series resistance of the diode, which would
not be accounted for if the average output current and
forward voltage were used in the equations. Finally, this
T
I
D(PEAK)
D
= T
OUT
A
) the peak diode current can be several times
+ P
=
38621 F21
n
1
R(SENSE)
• 1+
F
) measured at the peak current, not
2
• R
•
TH(JA)
1– D
I
O(MAX)
MAX
IN
38621f
to