ltc3406ab-2 Linear Technology Corporation, ltc3406ab-2 Datasheet - Page 7

no-image

ltc3406ab-2

Manufacturer Part Number
ltc3406ab-2
Description
2.25mhz, 600ma Synchronous Step-down Regulator In Thinsot
Manufacturer
Linear Technology Corporation
Datasheet
OPERATION
Main Control Loop
The LTC3406AB-2 uses a constant frequency, current
mode step-down architecture. Both the main (P-channel
MOSFET) and synchronous (N-channel MOSFET) switches
are internal. During normal operation, the internal top power
MOSFET is turned on each cycle when the oscillator sets
the RS latch, and turned off when the current comparator,
I
which I
of error amplifi er EA. When the load current increases,
it causes a slight decrease in the feedback voltage, V
relative to the 0.6V reference, which in turn, causes the
EA amplifi er’s output voltage to increase until the average
inductor current matches the new load current. While the
top MOSFET is off, the bottom MOSFET is turned on until
either the inductor current starts to reverse, as indicated
by the current reversal comparator I
of the next clock cycle.
The main control loop is shut down by grounding RUN,
resetting the internal soft-start. Re-enabling the main
control loop by pulling RUN high activates the internal
soft-start, which slowly ramps the output voltage over
approximately 0.9ms until it reaches regulation.
Pulse Skipping Mode Operation
At light loads, the inductor current may reach zero or
reverse on each pulse. The bottom MOSFET is turned off
by the current reversal comparator, I
voltage will ring. This is discontinuous mode operation,
and is normal behavior for the switching regulator. At
very light loads, the LTC3406AB-2 will automatically skip
COMP
, resets the RS latch. The peak inductor current at
COMP
resets the RS latch, is controlled by the output
(Refer to Functional Diagram)
RCMP
RCMP
, or the beginning
, and the switch
FB
,
pulses in pulse skipping mode operation to maintain output
regulation. Refer to the LTC3406A data sheet if Burst Mode
operation is preferred.
Dropout Operation
As the input supply voltage decreases to a value approach-
ing the output voltage, the duty cycle increases toward the
maximum on-time. Further reduction of the supply voltage
forces the main switch to remain on for more than one cycle
until it reaches 100% duty cycle. The output voltage will
then be determined by the input voltage minus the voltage
drop across the P-channel MOSFET and the inductor.
An important detail to remember is that at low input supply
voltages, the R
(see Typical Performance Characteristics). Therefore,
the user should calculate the power dissipation when the
LTC3406AB-2 is used at 100% duty cycle with low input
voltage (See Thermal Considerations in the Applications
Information section).
Slope Compensation and Inductor Peak Current
Slope compensation provides stability in constant fre-
quency architectures by preventing subharmonic oscil-
lations at high duty cycles. It is accomplished internally
by adding a compensating ramp to the inductor current
signal at duty cycles in excess of 40%. Normally, this
results in a reduction of maximum inductor peak current
for duty cycles >40%. However, the LTC3406AB-2 uses
a patented scheme that counteracts this compensating
ramp, which allows the maximum inductor peak current
to remain unaffected throughout all duty cycles.
DS(ON)
of the P-channel switch increases
LTC3406AB-2
3406ab2f
7

Related parts for ltc3406ab-2