s-35199a01 Seiko Instruments Inc., s-35199a01 Datasheet - Page 3
![no-image](/images/no-image-200.jpg)
s-35199a01
Manufacturer Part Number
s-35199a01
Description
3-wire Real-time Clock
Manufacturer
Seiko Instruments Inc.
Datasheet
1.S-35199A01.pdf
(54 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Rev.1.0
Pin Function
•
•
•
•
•
•
•
•
•
•
•
This pin is to data input/output for serial interface. When the CS pin is in “H”, the SIO pin inputs/outputs data by
CS (input for chip select) pin
This pin is to input chip select, has a pull-down resistor. Communication is available when this pin is in “H” level. If not
using communication, set this pin “L” or open.
SIO (I/O for serial data) pin
synchronizing with a clock pulse from the SCK pin. The status is in high impedance when the CS pin is in “L” or open,
so that the S-35199A01 does not transmit data. Setting the CS pin to “H” level from “L” or open, this SIO pin goes in the
input status so that it receives the command data. This pin has CMOS input and Nch open drain output.
This pin is to input a clock pulse for serial interface. When the CS pin is in “H”, the SIO pin inputs/outputs data by
synchronizing with the clock pulse. When the CS pin is in “L” or open, the SCK pin does not accept inputting a clock
pulse.
XIN, XOUT (crystal oscillator connect) pin
Connect a crystal oscillator between XIN and XOUT.
This pin outputs a signal of interrupt, or a clock pulse. By using the status register 2, users can select either of; alarm 1
interrupt, alarm 2 interrupt, output of user-set frequency, per-minute edge interrupt, minute-periodical interrupt 1,
minute-periodical interrupt 2, or 32.768 kHz output. This pin has Nch open drain output.
CTRL (F32K output control) pin
This pin is to control output from the F32K pin, has a pull-down resistor. This pin outputs a clock pulse from the F32K pin
when the CTRL pin is in “H”. It does not do so when the CTRL pin is in “L” or open.
Set this CTRL pin to “L” or open at power-on. To output 32.768 kHz from the F32K pin, after power-on, set the CTRL pin
to “H” more than one sec after.
F32K (32.768 kHz output) pin
This pin has the function to output-control, outputs 32.768 kHz. When the CTRL pin is in “H”, this pin outputs the 32.768
kHz clock pulse, when the CTRL pin is in “L” or open, the status is in high impedance. This pin has Nch open drain
output.
FOUT (output for clock pulse signal) pin
This pin is to output the clock pulse selected by users. Users can select the frequency by using the FOUT setting
register 1 and 2. This pin outputs “L” at power-on. This pin has CMOS output.
VDD (positive power supply) pin
Connect this VDD pin with a positive power supply. Regarding the values of voltage to be applied, refer to “
Recommended Operation Conditions” .
VDDL (positive power supply for FOUT output) pin
This pin is for positive power supply for the FOUT pin’s output. Set the value of voltage to be applied as V
VSS pin
Connect this VSS pin to GND.
INT (output for interrupt signal) pin
SCK (input for serial clock) pin
_00
Seiko Instruments Inc.
3-WIRE REAL-TIME CLOCK
S-35199A01
DDL
≤ V
DD
.
3