maxq2010-rfx Maxim Integrated Products, Inc., maxq2010-rfx Datasheet - Page 28

• Manufacturer Part Number: maxq2010-rfx
• Description: 16-bit Mixed-signal Microcontroller With Lcd
• Manufacturer: Maxim Integrated Products, Inc.

16-Bit Mixed-Signal Microcontroller with LCD
data-available interrupt interval bits (ADDAINV). The
ADDAI can be set in 1, 2, 3, 4, 5, 6, 7, 8, 12, or 16 sam-
ples intervals. For a sequence that uses only one con-
figuration register, setting ADDAINV = 00 generates an
interrupt with the same interval as ADDAINV = 01, both
of which set the ADDAI at every ADC sample. When the
ADDAI is set, the last memory location written by ADC
will also be written to ADDADDR.
The MAXQ2010 microcontroller incorporates an LCD
controller that interfaces to common low-voltage dis-
plays. By incorporating the LCD controller into the
microcontroller, the design requires only an LCD glass
rather than a considerably more expensive LCD mod-
ule. Every character in an LCD glass is composed of
one or more segments, each of which is activated by
selecting the appropriate segment and common signal.
The microcontroller can multiplex combinations of up to
43 segment outputs (SEG0 to SEG42) and four com-
mon signal outputs (COM0 to COM3). Unused segment
outputs can be used as general-purpose port pins.
The segments are easily addressed by writing to dedi-
cated display memory. Once the LCD controller set-
tings and display memory have been initialized, the
21-byte display memory is periodically scanned, and
the segment and common signals are generated auto-
matically at the selected display frequency. No addi-
tional processor overhead is required while the LCD
Figure 7. ADC Block Diagram
28
______________________________________________________________________________________
REFERENCE
REFERENCE
EXTERNAL
INTERNAL
AVDD
ADC REFERENCE
LCD Controller
AVDD
AVSS
ADC CONTROL
12-BIT
SAR
controller is running. Unused display memory can be
used for general-purpose storage.
The design is further simplified and cost reduced by
the inclusion of software-adjustable internal voltage-
dividers to control display contrast, using either V
or an external voltage. If desired, contrast can also be
controlled with an external resistance. The features of
the LCD controller include the following:
• Automatic LCD segment and common-drive signal
• Four display modes supported:
• Up to 43 segment outputs and four common-signal
• 21 bytes (168 bits) of display memory
• Flexible LCD clock source, selectable from 32kHz or
• Adjustable frame frequency
• Internal voltage-divider resistors eliminate require-
• Internal adjustable resistor allows contrast adjustment
generation
outputs
HFClk/512
ment for external components
without external components
Static (COM0)
1/2 duty multiplexed with 1/2 bias voltages (COM[0:1])
1/3 duty multiplexed with 1/3 bias voltages (COM[0:2])
1/4 duty multiplexed with 1/3 bias voltages (COM[0:3])
MULTIPLEXER
TRACK/HOLD
INPUT
AND
ADC INTERRUPT
AN7
AN6
AN5
AN4
AN3
AN2
AN1
AN0
DDIO