epm7064ae Altera Corporation, epm7064ae Datasheet - Page 26

• Manufacturer Part Number: epm7064ae
• Description: Programmable Logic Device
• Manufacturer: Altera Corporation

MAX 7000A Programmable Logic Device Data Sheet
Power
Sequencing &
Hot-Socketing
Design Security
Generic Testing
26
Because MAX 7000A devices can be used in a mixed-voltage environment,
they have been designed specifically to tolerate any possible power-up
sequence. The V
order.
Signals can be driven into MAX 7000AE devices before and during power-
up (and power-down) without damaging the device. Additionally,
MAX 7000AE devices do not drive out during power-up. Once operating
conditions are reached, MAX 7000AE devices operate as specified by the
user.
MAX 7000AE device I/O pins will not source or sink more than 300 µA of
DC current during power-up. All pins can be driven up to 5.75 V during
hot-socketing, except the OE1 and GLCRn pins. The OE1 and GLCRn pins
can be driven up to 3.6 V during hot-socketing. After V
reach the recommended operating conditions, these two pins are 5.0-V
tolerant.
EPM7128A and EPM7256A devices do not support hot-socketing and may
drive out during power-up.
All MAX 7000A devices contain a programmable security bit that controls
access to the data programmed into the device. When this bit is
programmed, a design implemented in the device cannot be copied or
retrieved. This feature provides a high level of design security because
programmed data within EEPROM cells is invisible. The security bit that
controls this function, as well as all other programmed data, is reset only
when the device is reprogrammed.
MAX 7000A devices are fully tested. Complete testing of each
programmable EEPROM bit and all internal logic elements ensures 100%
programming yield. AC test measurements are taken under conditions
equivalent to those shown in
erased during early stages of the production flow.
CCIO
and V
CCINT
Figure
power planes can be powered in any
9. Test patterns can be used and then
Altera Corporation
CCINT
and V
CCIO