cy8c26233-24sxit Cypress Semiconductor Corporation., cy8c26233-24sxit Datasheet - Page 114
![no-image](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__sml.jpg)
cy8c26233-24sxit
Manufacturer Part Number
cy8c26233-24sxit
Description
8-bit Programmable System-on-chip Psoc? Microcontrollers
Manufacturer
Cypress Semiconductor Corporation.
Datasheet
1.CY8C26233-24SXIT.pdf
(148 pages)
- Current page: 114 of 148
- Download datasheet (2Mb)
The Watchdog Timer period is automatically set to be 3
counts of the Sleep Timer overflows. This represents
between two and three sleep intervals depending on the
count in the Sleep Timer at the previous WDT clear.
When this timer reaches 3, a WDR is generated.
The user can either clear the WDT, or the WDT and the
Sleep Timer. Whenever the user writes to the Reset
WDT Register (RES_WDT), the WDT will be cleared. If
the data that is written is the hex value 38H, the Sleep
Timer will also be cleared at the same time.
Table 94:
Reset WDT Register (RES_WDT, Address = Bank 0, E3h)
11.4
There are three sleep states that can be used to lower
the overall power consumption on the device. The three
states are CPU Sleep, Analog Sleep, and Full Sleep.
The CPU can only be put to sleep by the firmware. This
is accomplished by setting the Sleep Bit in the Status
and Control Register (CPU_SCR). This stops the CPU
from executing instructions, and the CPU will remain
asleep until an interrupt comes pending, or there is a
reset event (either a Power On Reset, or a Watchdog
Timer Reset). While in the CPU Sleep state, all clocking
signals derived from the Internal Main Oscillator are
inactivated, including the 48M , 24M , 24V1 , and 24V2
system clocking signals. The Internal Low Speed Oscilla-
tor will continue to operate during the CPU Sleep state.
The function of any analog or digital PSoC block that is
clocked from these system-clocking signals will stop dur-
ing the CPU Sleep state.
The user can also put all the analog PSoC block circuits
to sleep. This is accomplished by resetting the Analog
Array Power Control bits in the Analog Reference Con-
trol Register (ARF_CR), which overrides the individual
114
Bit [7:0] : Data [7:0] Any write to this register will clear Watchdog Timer, a write of 38h will also clear the Sleep Timer
Read/Write
Bit Name
Bit #
POR
Sleep States
Reset WDT Register
Data [7]
RW
7
0
Data [6]
RW
Cypress MicroSystems CY8C25122/CY8C26233/CY8C26443/CY8C26643 Family Data Sheet
6
0
Document #: 38-12010 CY Rev. ** CMS Rev. 3.20
Data [5]
RW
5
0
Data [4]
RW
4
0
This timer chain is also used to time the startup for the
external 32 kHz crystal oscillator. When selecting the
external 32 kHz oscillator, a value of 1 second must be
selected as the sleep interval. When the sleep interrupt
occurs, the 32 kHz oscillator source will switch from
internal to the crystal. The device does not have to be
put into sleep for this event to occur. Note that if too short
of a sleep interval is given, the crystal oscillator will not
be stable prior to switch over and the results will be
unpredictable.
enable bits within each analog PSoC block. Setting the
Analog Array Power Control bits will restore the function
to those analog PSoC blocks that were previously in use.
The user should take into account the required settling
time after an analog PSoC block is enabled before it will
provide the maximum precision.
For greatest power savings, the user should put the
device in the Full Sleep state. This is accomplished by
first transitioning to the Analog Sleep state, and then set-
ting the Sleep Bit in the CPU_SCR Register to the Full
Sleep state. The CPU will be stopped at this point, and
either an interrupt or reset event is required to transition
back to the Analog Sleep state.
The Voltage Reference and Supply Voltage Monitor drop
into (fully functional) power-reduced states. All interrupts
remain active. The Internal Low Speed Oscillator
remains running (it will however drop into a less accu-
rate, low-power state). If enabled, the External Crystal
Oscillator will continue running throughout sleep (the
Internal Low Speed Oscillator is disabled if the External
Crystal Oscillator is selected). Only the occurrence of an
Data [3]
RW
3
0
Data [2]
RW
2
0
Data [1]
RW
1
0
September 5, 2002
Data [0]
RW
0
0
Related parts for cy8c26233-24sxit
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![CY37256VP208-66NI](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
Cypress Semiconductor [5V, 3.3V, ISRTM High-Performance CPLDs]
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C0831V-167AC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
CY7C0831V-167ACCypress Semiconductor [FLEx18-TM 3.3V 32K/64K/128K/256K/512K x 18 Synchronous Dual-Port RAM]
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![PLDC20G10-35PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
CMOS Generic 24-Pin Reprogrammable Logic Device
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C1021-15VC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
64K x 16 Static RAM
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C130-55PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
1K x 8 Dual-Port Static Ram
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY62128LL-70SC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
128K x 8 static RAM, standby current 20uA, 70ns
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C182-25PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
8Kx9 Static RAM
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C182-35PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
8Kx9 Static RAM
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C171A-25PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
4K x 4 Static RAM with Separate I/O
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C150-12PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
1024 x 4 Static R/W RAM
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C433-30PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
256/512/1K/2K/4K x 9 Asynchronous FIFO
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C172A-25PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
4K x 4 Static RAM with Separate I/O
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C172A-15PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
4K x 4 Static RAM with Separate I/O
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C172A-35PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
4K x 4 Static RAM with Separate I/O
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet:
![CY7C166-20PC](/images/manufacturer_photos/0/1/180/cypress_semiconductor_corporation__tmb.jpg)
Part Number:
Description:
16K x 4 Static RAM
Manufacturer:
Cypress Semiconductor Corporation.
Datasheet: