adl5801xcpz-r7 Analog Devices, Inc., adl5801xcpz-r7 Datasheet - Page 4
![no-image](/images/no-image-200.jpg)
adl5801xcpz-r7
Manufacturer Part Number
adl5801xcpz-r7
Description
High-ip3 10mhz ? 6ghz Active Mixer
Manufacturer
Analog Devices, Inc.
Datasheet
1.ADL5801XCPZ-R7.pdf
(8 pages)
ADL5801
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
Table 3. Pin Function Descriptions
Pin No.
1, 2, 5, 6,
8,12,14,
17, 19, 23
3, 4
7, 24
9
10
11
13
15, 16
18
21,20
22
Mnemonic
GND
LOIP, LOIN
VPLO
ENBL
ADJ
DETO
VPDT
RFIP, RFIN
VPRF
IFOP, IFON
NC
Function
Device Common (DC Ground).
Differential LO input terminals. Internally matched to 50Ω. Must be ac-coupled.
Positive Supply Voltage for LO system.
Device Enable. Pull high to disable the device, pull low to enable.
IP3 Bias Adjustment. The voltage presented to the ADJ pin sets the internal bias of the mixer core and allows
for adaptive control of the IIP3 and NF characteristics of the mixer core.
Detector Output. DETO pin should be loaded with a capacitor to ground. The developed voltage is
proportional to the RMS input level. By connecting the DETO output voltage to the ADJ input pin the part
will auto bias and increase IP3 performance when presented with large signal input levels.
Positive Supply Voltage for Detector.
Differential RF input terminal. Internally matched to 50Ω differential input impedance. Must be ac-coupled.
Positive Supply Voltage for RF Input system.
Differential IF Output terminals. Need to apply bias through pull-up choke inductors or center tap of the IF
transfomer.
Not Connected.
Figure 2. Pin Configuration
REV. PrA | Page 4 of 8
Preliminary Technical Data