bu7265g ROHM Co. Ltd., bu7265g Datasheet - Page 16

• Manufacturer Part Number: bu7265g
• Description: General-purpose Operational Amplifier / Comparator Series
• Manufacturer: ROHM Co. Ltd.

●Notes for Use
BU7265G,BU7265SG,BU7271G,BU7271SG,
BU7411G,BU7411SG,BU7421G,BU7421SG
© 2010 ROHM Co., Ltd. All rights reserved.
www.rohm.com
10) The IC destruction caused by capacitive load
11) Decupling capacitor
12) Latch up
13) Crossover distortion
1) Absolute maximum ratings
2) Applied voltage to the input terminal
3) Operating power supply (split power supply/single power supply)
4) Power dissipation (Pd)
5) Short circuits between pins and incorrect mounting
6) Output short circuit
8) Usage of IC
9) Testing IC on the set board
7) Using under strong electromagnetic field
Absolute maximum ratings are the values which indicate the limits,within which the given voltage range can be safely
charged to the terminal.However, it does not guarantee the circuit operation.
For normal circuit operation of voltage comparator, please input voltage for its input terminal within input common mode
voltage VDD+0.3[V]. Then, regardless of power supply voltage,VSS-0.3[V] can be applied to input terminals without
deterioration or destruction of its characteristics.
The operational amplifier operates if a given level of voltage is applied between VDD and VSS. Therefore, the operational
amplifier can be operated under single power supply or split power supply.
If the IC is used under excessive power dissipation. An increase in the chip temperature will cause deterioration of the
radical characteristics of IC. For example, reduction of current capability.Take consideration of the effective power
dissipation and thermal design with a sufficient margin. Pd is reference to the provided power dissipation curve.
Short circuits between pins and incorrect mounting when mounting the IC on a printed circuits board, take notice of the
direction and positioning of the IC.If IC is mounted erroneously, It may be damaged. Also, when a foreign object is inserted
between output, between output and VDD terminal or VSS terminal which causes short circuit, the IC may be damaged.
If short circuit occurs between the output terminal and VDD terminal , excessive in output current may flow and generate
heat , causing destruction of the IC.Take due care.
Be careful when using the IC under strong electromagnetic field because it may malfunction.
When stress is applied to the IC through warp of the printed circuit board, The characteristics may fluctuate due to the
piezo effect. Be careful of the warp of the printed circuit board.
When testing IC on the set board, in cases where the capacitor is connected to the low impedance, make sure to
discharge per fabrication because there is a possibility that IC may be damaged by stress.When removing IC from the set
board, it is essential to cut supply voltage. As a countermeasure against the static electricity, observe proper grounding
during fabrication process and take due care when carrying and storage it.
The transistors in circuits may be damaged when VDD terminal and VSS terminal is shorted with the charged output
terminal capacitor.When IC is used as a operational amplifier or as an application circuit, where oscillation is not activated
by an output capacitor,the output capacitor must be kept below 0.1[μF] in order to prevent the damage mentioned above.
Insert the decupling capacitance between VDD and VSS, for stable operation of operational amplifier.
Be careful of input voltage that exceed the VDD and VSS. When CMOS device have sometimes occur latch up operation.
And protect the IC from abnormaly noise.
Inverting amplifier generates crossover distortion when feed back resistance value is small. To suppress the crossover
distortion, connect a resistor between the output terminal and VSS Then increse the bias current to enable class A output
stage operation.
Fig.100 Pull down resistance
Feed back resistance
16/17
-
+
VSS
VDD
Pull down resistance
Technical Note
2010.03 - Rev.A