hip1011d Intersil Corporation, hip1011d Datasheet - Page 4

• Manufacturer Part Number: hip1011d
• Description: Dual Plug Controller
• Manufacturer: Intersil Corporation

Pin Descriptions
PIN NO.
15, 28
20, 23
21, 22
16, 27
17, 26
19, 24
18, 25
4, 11
3, 12
2, 13
1, 14
6, 9
7, 8
10
5
DESIGNATOR
PWRON
M12VIN
3VISEN
5VISEN
M12VG
M12VO
OCSET
3V5VG
12VIN
FLTN
12VG
12VO
VSS
3VS
5VS
Gate of Internal NMOS Connect a capacitor between M12VG and M12VO to set the start-up ramp for the M12V
Gate of Internal PMOS Connect a capacitor between 12VG and 12VO to set the start-up ramp for the +12V supply.
3.3V/5V Gate Output
Switched 12V Output
3.3V Current Sense
5V Current Sense
Power On Control
4
Overcurrent Set
Switched -12V
Fault Output
3.3V Source
FUNCTION
5V Source
-12V Input
12V Input
Ground
Output
-12V Supply Input. Also provides power to the -12V overcurrent circuitry.
5V CMOS Fault Output; LOW = FAULT. An optional capacitor may be place from this pin to
ground to provide additional immunity from power supply glitches.
Drive the gates of the 3.3V and 5V MOSFETs. Connect a capacitor to ground to set the
start-up ramp. During turn on, this capacitor is charged with a 25 A current source.
UV comparator disabled when this pin below 9.6V nominal.
12V supply input for IC and 12VO. Both 12VIns to be connected to a single +12V supply.
Connect to the load side of the current sense resistor in series with source of external 3.3V
MOSFET.
Connect to source of 3.3V MOSFET. This connection along with (3VISEN) senses the
voltage drop across the sense resistor.
Connect to source of 5V MOSFET switch. This connection along with (5VISEN) senses the
voltage drop across the sense resistor.
Connect to the load side of the current sense resistor in series with source of external 5V
MOSFET.
Controls all four switches. High to turn switches ON, Low to turn them OFF.
This capacitor is charged with a 25 A current source during start-up.
UV comparator disabled when this pin >1.4Vnominal.
Switched 12V output. Rated for 0.5A.
supply. This capacitor is charged with 25 A during start-up.
Switched 12V Output. Rated for 100mA.
Connect a resistor from this pin to ground to set the overcurrent trip point of all eight
switches. All eight over current trips can be programmed by changing the value of this
resistor. The default (6.04k , 1%) is compatible with the maximum allowable currents as
outlined in the PCI specification.
Connect to common of power supplies.
HIP1011D
DESCRIPTION