hip6501a Intersil Corporation, hip6501a Datasheet - Page 12
hip6501a
Manufacturer Part Number
hip6501a
Description
Triple Linear Power Controller With Acpi Control Interface
Manufacturer
Intersil Corporation
Datasheet
1.HIP6501A.pdf
(14 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
hip6501aCB
Manufacturer:
INTERSIL
Quantity:
5 514
Part Number:
hip6501aCB
Manufacturer:
HAR
Quantity:
20 000
Company:
Part Number:
hip6501aCB-T
Manufacturer:
Skyworks
Quantity:
74
Company:
Part Number:
hip6501aCBZ
Manufacturer:
EL
Quantity:
7 172
Q4
If a P-Channel MOSFET is used to switch the 5VSB output
of the ATX supply into the 5V
S4/S5 states (as dictated by EN5VDL status), then, similar to
the situation where Q1 is a MOSFET, the selection criteria of
this device is also proper voltage budgeting. The maximum
r
so a logic level MOSFET needs to be selected. If a PNP
device is chosen to perform this function, it has to have a low
saturation voltage while providing the maximum sleep-state
current and have a current gain sufficiently high to be
saturated using the minimum drive current (typically 20mA;
4mA during soft-start).
DS(ON)
, however, has to be achieved with only 4.5V of V
12
DUAL
output during S3 and
GS
HIP6501A
,
Q3, Q5
The two N-Channel MOSFETs are used to switch the 3.3V
and 5V inputs provided by the ATX supply into the
3.3VDUAL and 5VDUAL outputs, respectively, while in
active (S0, S1) states. Similar r
cases as well, unlike the PMOS, however, these NMOS
transistors get the benefit of an increased V
(approximately 8V and 7V, respectively).
Q2
The NPN transistor used as sleep-state pass element on the
3.3V
at V
operating temperature range.
CE
DUAL
= 1.5V, and I
output must have a minimum current gain of 100
CE
= 500mA throughout the in-circuit
DS(ON)
criteria apply in these
GS
December 30, 2004
drive
FN4749.6