cop8tab9 National Semiconductor Corporation, cop8tab9 Datasheet - Page 40

• Manufacturer Part Number: cop8tab9
• Description: 8-bit Cmos Flash Microcontroller With 2k Byte Or 4k Byte Memory
• Manufacturer: National Semiconductor Corporation

www.national.com
16.0 MICROWIRE/PLUS
mode may cause the current SK clock for the SIO shift
register to be narrow. For safety, the BUSY flag should only
be set when the input SK clock is in the idle phase.
16.2 MICROWIRE/PLUS MASTER MODE OPERATION
In the MICROWIRE/PLUS Master mode of operation the
shift clock (SK) is generated internally. The MICROWIRE
16.3 MICROWIRE/PLUS SLAVE MODE OPERATION
In the MICROWIRE/PLUS Slave mode of operation the SK
clock is generated by an external source. Setting the MSEL
bit in the CNTRL register enables the SO and SK functions
onto the G Port. The SK pin must be selected as an input
and the SO pin is selected as an output pin by setting and
resetting the appropriate bits in the Port G configuration
register. Table 19 summarizes the settings required to enter
the Slave mode of operation.
This table assumes that the control flag MSEL is set.
The user must set the BUSY flag immediately upon entering
the Slave mode. This ensures that all data bits sent by the
Config. Bit
G4 (SO)
TABLE 19. MICROWIRE/PLUS Mode Settings
1
0
1
0
Config. Bit
G5 (SK)
1
1
0
0
STATE
STATE
Fun.
TRI-
TRI-
SO
SO
G4
Fun.
Ext.
Ext.
G5
Int.
SK
Int.
SK
SK
SK
FIGURE 28. MICROWIRE/PLUS Application
(Continued)
MICROWIRE/PLUS
Master
MICROWIRE/PLUS
Master
MICROWIRE/PLUS
Slave
MICROWIRE/PLUS
Slave
Operation
40
Master always initiates all data exchanges. The MSEL bit in
the CNTRL register must be set to enable the SO and SK
functions onto the G Port. The SO and SK pins must also be
selected as outputs by setting appropriate bits in the Port G
configuration register. In the slave mode, the shift clock
stops after 8 clock pulses. Table 19 summarizes the bit
settings required for Master mode of operation.
Master is shifted properly. After eight clock pulses the BUSY
flag is clear, the shift clock is stopped, and the sequence
may be repeated.
16.4 ALTERNATE SK PHASE OPERATION AND SK
IDLE POLARITY
The device allows either the normal SK clock or an alternate
phase SK clock to shift data in and out of the SIO register. In
both the modes the SK idle polarity can be either high or low.
The polarity is selected by bit 5 of Port G data register. In the
normal mode data is shifted in on the rising edge of the SK
clock and the data is shifted out on the falling edge of the SK
clock. The SIO register is shifted on each falling edge of the
SK clock. In the alternate SK phase operation, data is shifted
in on the falling edge of the SK clock and shifted out on the
rising edge of the SK clock. Bit 6 of Port G configuration
register selects the SK edge.
A control flag, SKSEL, allows either the normal SK clock or
the alternate SK clock to be selected. Resetting SKSEL
causes the MICROWIRE/PLUS logic to be clocked from the
normal SK signal. Setting the SKSEL flag selects the alter-
nate SK clock. The SKSEL is mapped into the G6 configu-
ration bit. The SKSEL flag will power up in the reset condi-
tion, selecting the normal SK signal.
20047537