xr16v794iv Exar Corporation, xr16v794iv Datasheet - Page 11
![no-image](/images/manufacturer_photos/0/2/243/exar_corporation_sml.jpg)
xr16v794iv
Manufacturer Part Number
xr16v794iv
Description
High Performance 2.25v To 3.6v Quad Uart With Fractional
Manufacturer
Exar Corporation
Datasheet
1.XR16V794IV.pdf
(53 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
xr16v794iv-F
Manufacturer:
LT
Quantity:
1 500
Company:
Part Number:
xr16v794iv-F
Manufacturer:
Exar Corporation
Quantity:
10 000
Company:
Part Number:
xr16v794ivTR-F
Manufacturer:
OMRON
Quantity:
12
XR16V794
HIGH PERFORMANCE 2.25V TO 3.6V QUAD UART WITH FRACTIONAL BAUD RATE
REV. 1.0.0
2.8
Receiver
The receiver section contains an 8-bit Receive Shift Register (RSR) and 64 bytes of FIFO which includes a
byte-wide Receive Holding Register (RHR). The RSR uses the 16X (or the 8X) clock for timing. It verifies and
validates every bit on the incoming character in the middle of each data bit. On the falling edge of a start or
false start bit, an internal receiver counter starts counting the number of 16X (or 8X) clocks. After 8 (or 4)
clocks the start bit period should be at the center of the start bit. At this time the start bit is sampled and if it is
still a logic 0 it is validated. Evaluating the start bit in this manner prevents the receiver from assembling a false
character. The rest of the data bits and stop bits are sampled and validated in this same manner to prevent
false framing. If there were any error(s), they are reported in the LSR register bits 2-4. Upon unloading the
receive data byte from RHR, the receive FIFO pointer is bumped and the error tags are immediately updated to
reflect the status of the data byte in RHR register. RHR can generate a receive data ready interrupt upon
receiving a character or delay until it reaches the FIFO trigger level. Furthermore, data delivery to the host is
guaranteed by a receive data ready time-out interrupt when data is not received for 4 word lengths as defined
by LCR[1:0] plus 12 bits time. This is equivalent to 3.7-4.6 character times. The RHR interrupt is enabled by
IER bit-0.
2.8.1
Receive Holding Register (RHR) - Read-Only
The Receive Holding Register is an 8-bit register that holds a receive data byte from the Receive Shift
Register. It provides the receive data interface to the host processor. The RHR register is part of the receive
FIFO of 64 bytes by 11-bits wide, the 3 extra bits are for the 3 error tags to be reported in LSR register. When
the FIFO is enabled by FCR bit-0, the RHR contains the first data character received by the FIFO. After the
RHR is read, the next character byte is loaded into the RHR and the errors associated with the current data
byte are immediately updated in the LSR bits 2-4.
F
7. R
O
-FIFO M
IGURE
ECEIVER
PERATION IN NON
ODE
16X or 8X Clock
Receive Data Shift
Data Bit
Register (RSR)
Validation
Receive Data Characters
Error
Receive
Receive Data
Tags in
Data Byte
RHR Interrupt (ISR bit-2)
Holding Register
LSR bits
and Errors
(RHR)
4:2
RXFIFO1
11