hsp50016 Intersil Corporation, hsp50016 Datasheet - Page 3

• Manufacturer Part Number: hsp50016
• Description: Digital Down Converter
• Manufacturer: Intersil Corporation

When a successful compare has been done, the software
message returned is:
The most common causes of test failures are incorrect board
jumper settings, incorrect comm port selection, or a
corrupted eval.cfg file. It is helpful to delete the file
TEST_OUT.DAT, prior to the test, to ensure that DDC.CHK
runs properly and that a new TEST_OUT.DAT file was
created.
- Comparing files TEST_OUT.DAT and CMPRFILE.DAT
- FC: No differences encountered
QOUT SELECT
IQSTB SELECT
FIGURE 1. LAYOUT OF HSP50016-EV SHOWING DEFAULT JUMPER CONFIGURATION
JP20
3-3
1
JP19
1
HSP50016-EV
P1
P2
NOTE: if the operating system precedes DOS 6.0, the
user should answer NO to the COMP command prompt
to compare additional files. DOS Version 6.0 and above
use a different file compare command, so this step is
not necessary. DDCCHK checks the version
automatically and executes the proper compare routine.
The DDCCHK system test assumes that the LPT1 printer port
is being used for communication with the HSP50016-EV. If
another printer port is used, the Command Line Interface,
DDCCMD, must be used to configure the software for using
the correct port (see DDCCMD’s PPC and PP# command).
JP1
JP2
JP3
JP5
JP6
JP7
JP8
JP9
JP10
JP11
JP12
JP13
JP14
JP15
JP16
JP17
JP18
J2
J3
J1
EXT_CLK
OSC_CLK
PC_CLK
DATA_OE
ADDR0
ADDR1
ADDR2
ADDR3
ADDR4
ADDR5
ADDR6
ADDR7
DDC_CLK_INV
OUT_CLK_INV
CLK_OUT
CLK_IN
TAP_SEL
CABLE
CLOCK
SELECT
OUTPUT
ENABLE
BOARD
ADDRESS
CLOCK
SELECT