msm7732a Oki Semiconductor, msm7732a Datasheet - Page 7
![no-image](/images/no-image-200.jpg)
msm7732a
Manufacturer Part Number
msm7732a
Description
Audio Codec
Manufacturer
Oki Semiconductor
Datasheet
1.MSM7732A.pdf
(28 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MSM7732A
Manufacturer:
OKI
Quantity:
5 000
FEDL7732A-01-01
OKI Semiconductor
MSM7732A-01
SG
Analog signal ground.
The output voltage of this pin is approximately 1.4 V. Put the bypass capacitors (10 µF in parallel with 0.1 µF
ceramic type) between this pin and AG to get the specified noise characteristics. During power-down, this output
voltage is 0 V.
AMPAI, AMPAO
Used for amplifier A. The pin AMPAI is connected to the amplifier A inverting input, and the pin AMPAO is
connected to the amplifier A output.
SWA, SWB, SWC
Used for the internal analog switch. The pin SWB connects to the pin SWA or the pin SWC. This is controlled by
CR1-B1.
SWD, SWE
Used for the internal analog switch. The pin SWD connects to the pin SWE or not. This is controlled by CR1-B2.
V
, V
DD
A
+3 V power supply for analog. V
is the digital power supply. V
is the analog power supply.
DD
A
Since these pins are separated in the device, connect them as close as possible on the PCB.
DG, AG1, AG2
Ground. DG is the digital system ground. AG1 and AG2 are connected to the analog system ground.
The DG pin must be kept as close as possible to AG1 and AG2 on the PCB.
PDN
Power down and reset control input.
When set to digital “0”, the system changes to the power down state and control registers are reset. Since the power
down mode is controlled by a logical OR with CR0-B5 of the control register, set CR0-B5 to logic “0” when using
this pin.
Be sure to reset the control registers by executing this power down to keep this pin to digital “0” level for 200 ns or
longer after the power is turned on and V
exceeds 2.4 V.
DD
MCK
Master clock input.
The frequency must be 2.048 MHz. MCK can be asynchronous with SYNC and BCLK.
BCLK
Shift clock input for the PCM data.
The frequency is set in the range of 64 kHz to 2048 kHz.
7/28