msm7603 Oki Semiconductor, msm7603 Datasheet - Page 18

• Manufacturer Part Number: msm7603
• Description: Echo Canceler
• Manufacturer: Oki Semiconductor

¡ Semiconductor
NOTES ON USE
1. Set echo return loss (ERL) to be attenuated. If the echo return loss is set to be
2. Set the level of the analog input so that the PCM codec does not overflow.
3. The recommended input level is –10 to –20 dBm0. Refer to the characteristics
4. Applying the tone signal to this echo canceler for long duration may decrease echo
5. For changes in the echo path (retransmit, circuit switching during transmission,
6. When turning the power ON, set the PWDWN pin to "1" and input the basic clock
7. After power ON, be sure to reset the device.
8. After the power down mode is released (when PWDWN pin is changed to a "1" from
9. If this canceler is used to cancel acoustic echoes, an echo attenuation may be less
amplified, the echo cannot be eliminated.
Refer to the characteristics diagram for E. R. L. vs. echo attenuation quantity.
diagram for the RIN input level vs. echo attenuation quantity.
attenuation.
When used with the HD pin "L" (howling detector ON), this echo canceler may
operate faultily if, while a signal is input to the RIN pin, a tone signal with a higher
level than the signal being input to RIN is input to the SIN pin.
A signal should therefore be input either to the RIN pin or to the SIN pin. If,
however, the tone signal is input to the SIN pin while a signal is input to the RIN pin,
the ADP, HD, or HCL pin must be set to "H".
and so on), convergence may be difficult.
Perform a reset to make it converge.
If the state of the echo path changes after a reset, convergence may again be difficult.
In cases such as a change in the echo path, perform a reset each time.
simultaneously with power ON.
If the device is put into power down mode immediately after power ON, be sure
to input 10 or more clocks of the basic clock before setting to the power down mode.
a "0"), be sure to reset the device.
than 30 dB.
MSM7603/7603B
18/20