s5u1c33000c Epson Electronics America, Inc., s5u1c33000c Datasheet - Page 293

• Manufacturer Part Number: s5u1c33000c
• Description: Cmos 32-bit Single Chip Microcomputer S5u1c33000c Manual
• Manufacturer: Epson Electronics America, Inc.

16.5 Tool Bar
This section outlines the tool bar available with the db33.
16.5.1 Tool Bar Structure
The db33 has 18 buttons and a combo box in its tool bar, each one assigned to a frequently used command.
16.5.2 [Key break] Button
16.5.3 [Load file] Button
16.5.4 [Source], [Mix] and [Unassemble] Buttons
The display is switched between these modes based on the source line number or address shown at the top of the
[Source] window. These buttons are valid only when the [Source] window is open.
16.5.5 [Reset cold] and [Reset hot] Buttons
16.5.6 [Go], [Go to], [Step] and [Next] Buttons
S5U1C33000C MANUAL
(C COMPILER PACKAGE FOR S1C33 FAMILY) (Ver. 4)
[Unassemble]
[Key break]
[Reset cold]
[Load file]
[Reset hot]
[Source]
[Go to]
[Mix]
[Go]
This button forcibly breaks execution of the target program. This function can be used to cause
the program to break when the CPU is placed in standby (HALT or SLEEP) mode as you
execute the target program or when the program has fallen into an endless loop.
Note that the debug monitor mode does not support this function.
This button reads an object file in the srf33 format into the debugger. It performs the same
function when the lf command is executed. When you click [Load file], a dialog box for
opening a file appears on the screen, allowing you to choose the file you want to be debugged.
This button switches the display of the [Source] window to the source mode.
This button switches the display of the [Source] window to the mix mode (disassemble &
source).
This button switches the display of the [Source] window to the disassemble mode.
This button executes the target program beginning with the address indicated by the current PC.
It performs the same function when the g command is executed.
This button executes the target program from the address indicated by the current PC to the
cursor position in the [Source] window (i.e. the address of that line). It performs the same
function when the g <address> command is executed.
To select this button, the [Source] window must be open and you must have clicked on the
address line where you want the program to break. Selecting a break address by clicking on the
address line is valid for only the lines that have actual code, and is invalid for the source-only
lines.
This button cold-resets the CPU. It performs the same function when the rstc command is
executed.
This button hot-resets the CPU. It performs the same function when the rsth command is
executed.
EPSON
CHAPTER 16: DEBUGGER
277