jsh-01lwab1 ETC-unknow, jsh-01lwab1 Datasheet - Page 5

• Manufacturer Part Number: jsh-01lwab1
• Description: Gigabit Ethernet 1310 Limiting Transceiver, Reach
• Manufacturer: ETC-unknow

Power Supply Filter Component values
Component
L1, L2
Rx, Ry
C1, C5
C2, C3, C4
C6
Notes:
Option A is recommended for use in applications with space constraints. Power supply noise must be less than 100 mV
Option B is used in the module compliance board in SFF-8431.
*If the total series resistance of L1+C6 and L2+C5 exceeds the values of Rx and Ry in the table, then Rx and Ry can be omitted.
5
Power supply filtering is recommended for both the transmitter and receiver. Filtering
should be placed on the host assembly as close to the V
performance. V
Power supply filter component values from Figure 2 are shown in the table below
for two different implementations.
Option A
1.0
0.5*
10
0.1
Not required
10 G IGABIT ETHERNET SFP+ 1310 NM
LIMITING TRANSCEI vER, 10 KM REACH
cc,R
and V
cc,T
should have separate filters.
Option B
4.7
0.5*
22
0.1
22
p-p
.
cc
pins as possible for optimal
Units
μH
W
μF
μF
μF