evqpjj05t Panasonic Corporation of North America, evqpjj05t Datasheet - Page 7

• Manufacturer Part Number: evqpjj05t
• Description: Light Touch Switch
• Manufacturer: Panasonic Corporation of North America

Classification
Part Name
6. Prohibitions and precaution for handling
6.1 Soldering condition
6.3 Notes
6.2 Design instructions
1) After switches were soldered, please be careful not to clean switches with solvent.
2) Please flux don't into over the switch.
3) In the case of using soldering iron,soldering conditions shall be 350 ℃ max. 3 sec. max.
1) Please be cautions not to give excessive static load or shock to switches.
2) Please be careful not to pile up P.W.B. after switches were soldered.
3) A product shall be mounted properly by insert machine.
4) Preservation under high temperature and high humidity or corrosive gas should be avoided
5) Avoid the use of the switch under pushed ON condition is continued for a long time.
4) Right after switches were soldered, please be carefull not to load on the knobs of
1) Please refer to the land pattern plan Panasonic recommends on the 2nd page.
2) Design key top as fig-1. Design inclination of key top 4 deg. max. as fig-2.
Area of flux
Temperature of solder 260±5 ℃
Time of immersion
Soldering number
Printed wiring board
Preheat temperature
Preheat time
especially. When you need to preserve for a long period, do not open the carton.
1 time only and the tip of iron must not touch to terminals.
Soldering iron for re-soldering have to be 60W max.
switches.
(Recommended operation condition)
LIGHT TOUCH SWITCH
ITEM
REFERENCE SPECIFICATION
110℃ max.(Environmental temperature of soldering surface of P.W.B.)
60 sec. max.
1/2 max. of P.W.B. thickness
Within 5 sec.
Within 2 times (But should bring down heat of the first soldering.)
Single sided copper-clad laminates
fig-1
Panasonic Electronic Devices Co., Ltd.
Part No.
EVQPJJ05T
CONDITION
fig-2
Issue No.
20090984
7/10