evqp1f05m Panasonic Corporation of North America, evqp1f05m Datasheet - Page 6

no-image

evqp1f05m

Manufacturer Part Number
evqp1f05m
Description
Light Touch Switch
Manufacturer
Panasonic Corporation of North America
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
EVQP1F05M
Manufacturer:
PANASONIC
Quantity:
30 000
Part Number:
EVQP1F05M
Manufacturer:
PANASONIC
Quantity:
8 000
Classification
Part Name
6. Prohibitions and precaution for handling
6.2 Guide line for key top design.
6.1 Reflow soldering condition
6.3 Notes
1) Two times max. with directing the switch mounting side of P.W.B up.
2) Re-soldering by soldering iron shall be allowed under 350℃ max. 3 sec. max. 1 time only
1) Please be cautions not to give excessive static load or shock to switches.
2) Please be careful not to pile up P.W.B. after switches were soldered.
3) Preservation under high temperature and high humidity or corrosive gas should be avoided
4) Avoid pressing the film portion of the product with sharp-edged object.
6) Avoid the use of the switch under pushed ON condition is continued for a long time.
7) There is a possibility the flux from solder paste infiltrates into the body if plenty of
5) Cleaning
1) Please refer to the land pattern plan Panasonic recommends on the 2nd page.
2) The key top shall have flat area on the top as Dia 2mm or greater than it.
3) The deflection of key top when switch is actuated shall be whithin 10° as fig-1.
4) The center of key top for switch operation needs to locate within 1mm max.
5) Pre-load on the switch between key top and switch shall be 0.2mm max. as fig-2.
If you have any question about above instruction and any devation
per our recommendation,let us know.
and the tip of iron must not touch to terminals.
Soldering iron for re-soldering have to be 60W max.
especially. When you need to preserve for a long period, do not open the carton.
・Cleaning after soldering is not allowed.When cleaning is required this switch should be
・If flux or solder is scattered on the surface of P.W.B when soldering, characteristics
Also please avoid putting additional land by the switch on the P.W.B.
solder paste was applied by switch on the P.W.B.
So we recommend to use our proposed land design in order to prevent above problem.
of this product may be damaged.
soldered after the cleaning.
LIGHT TOUCH SWITCH
REFERENCE SPECIFICATION
Panasonic Electronic Devices Co., Ltd.
Part No.
fig-1
EVQP1F05M
fig-2
Issue No.
20090884
6/8

Related parts for evqp1f05m