evqp0q02q Panasonic Corporation of North America, evqp0q02q Datasheet - Page 6

• Manufacturer Part Number: evqp0q02q
• Description: Light Touch Switch
• Manufacturer: Panasonic Corporation of North America

Classification
Part Name
6. Prohibitions and precaution for handling
6.1 Reflow soldering condition
6.2 Design instructions
6.3 Notes
1) Please be cautions not to give excessive static load or shock to switches.
2) Please be careful not to pile up P.W.B. after switches were soldered.
3) Preservation under high temperature and high humidity or corrosive gas should be avoided
4) Cleaning
6) There is a possibility the flux from solder paste infiltrates into the body if plenty of
1) Two times max. with directing the switch mounting side of P.W.B up.
2) Re-soldering by soldering iron shall be allowed under 350℃ max. 3 sec. max. 1 time only
1) Please refer to the land pattern plan Panasonic recommends on the 2nd page.
2) The key top shall have flat area on the top as Dia 2mm or greater than it.
3) The deflection of key top when switch is actuated shall be whithin 10° as fig-1.
4) The center of key top for switch operation needs to locate within 1mm max.
5) Pre-load on the switch between key top and switch shall be 0.2mm max. as fig-2.
If you have any question about above instruction and any devation
per our recommendation,let us know.
5) Avoid the use of the switch under pushed ON condition is continued for a long time.
and the tip of iron must not touch to terminals.
Soldering iron for re-soldering have to be 60W max.
especially. When you need to preserve for a long period, do not open the carton.
･If flux or solder is scattered on the surface of P.W.B when soldering, characteristics
･Cleaning after soldering is not allowed.When cleaning is required this switch should be
Also please avoid putting additional land by the switch on the P.W.B.
solder paste was applied by switch on the P.W.B.
So we recommend to use our proposed land design in order to prevent above problem.
of this product may be damaged.
soldered after the cleaning.
LIGHT TOUCH SWITCH
Panasonic Electronic Devices Malaysia Sdn. Bhd.
REFERENCE SPECIFICATION
Part No.
EVQP0Q02Q
fig-1
fig-2
Issue No.
20091136
6/9