mx25l512 Macronix International Co., mx25l512 Datasheet - Page 15

• Manufacturer Part Number: mx25l512
• Description: 512k-bit [x 1] Cmos Serial Flash
• Manufacturer: Macronix International Co.

(14) Read Electronic Manufacturer ID & Device ID (REMS)
The REMS instruction is an alternative to the Release from Power-down/Device ID instruction that provides both the JEDEC
assigned manufacturer ID and the specific device ID.
The REMS instruction is very similar to the Release from Power-down/Device ID instruction. The instruction is initiated
by driving the CS# pin low and shift the instruction code "90h" followed by two dummy bytes and one bytes address (A7~A0).
After which, the Manufacturer ID for MXIC (C2h) and the Device ID are shifted out on the falling edge of SCLK with most
significant bit (MSB) first as shown in figure 25. The Device ID values are listed in Table of ID Definitions on page 16. If
the one-byte address is initially set to 01h, then the device ID will be read first and then followed by the Manufacturer ID.
The Manufacturer and Device IDs can be read continuously, alternating from one to the other. The instruction is completed
by driving CS# high.
P/N: PM1214
Table of ID Definitions:
1. RDID:
MX25L512
2. RES:
MX25L512
3. REMS:
MX25L512
manufacturer ID
manufacturer ID
C2
C2
15
memory type
electronic ID
20
05
MX25L512
device ID
05
memory density
10
REV. 1.4, MAR. 24, 2008