NBB-400-D RFMD [RF Micro Devices], NBB-400-D Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
NBB-400-D
Manufacturer Part Number
NBB-400-D
Description
CASCADABLE BROADBAND GaAs MMIC AMPLIFIER DC TO 8GHz
Manufacturer
RFMD [RF Micro Devices]
Datasheet
1.NBB-400-D.pdf
(10 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
NBB-400-D
Manufacturer:
RFMD
Quantity:
5 000
Company:
Part Number:
NBB-400-D-SB
Manufacturer:
RFMD
Quantity:
5 000
Die Attach
Die Wire Bonding
Notes
1
inspection personnel to determine final visual acceptance of die product prior to shipping to customers.
2
imize material shift. However, due to the physical size of die-level product, RFMD does not guarantee that material will
not shift during transit, especially under extreme handling circumstances. Product replacement due to material shift will
be at the discretion of RFMD.
4-38
RFMD Document #6000152 - Die Product Final Visual Inspection Criteria. This document provides guidance for die
RFMD takes precautions to ensure that die product is shipped in accordance with quality standards established to min-
• The die attach process mechanically attaches the die to the circuit substrate. In addition, the utilization of proper die
• Die should be mounted to a clean, flat surface. Epoxy or eutectic die attach are both acceptable attachment meth-
• All connections should be made on the topside of the die. It is essential to performance that the backside be well
• Some die utilize vias for effective grounding. Care must be exercised when mounting die to preclude excess run-out
• Electrical connections to the chip are made through wire bonds. Either wedge or ball bonding methods are accept-
• All bond wires should be made as short as possible.
NBB-400
attach processes electrically connect the ground to the trace on which the chip is mounted. It also establishes the
thermal path by which heat can leave the chip.
ods. Top and bottom metallization are gold. Conductive silver-filled epoxies are recommended. This procedure
involves the use of epoxy to form a joint between the backside gold of the chip and the metallized area of the sub-
strate.
grounded and that the length of topside interconnects be minimized.
on the topside.
able practices for wire bonding.
Rev A8 060124