UFL-2LP-04-A ETC1 [List of Unclassifed Manufacturers], UFL-2LP-04-A Datasheet - Page 6

• Manufacturer Part Number: UFL-2LP-04-A
• Description: SMT Ultra-Miniature Coaxial Connectors-Mating Heights Owing to the Lowest Profile and the Lightest
• Manufacturer: ETC1 [List of Unclassifed Manufacturers]

6
1. Plugs
2. Receptacles
(1) Connection/
(2) Permissible load on
(3) Precautions
(1) Recommended
(2) Recommended hand
(3) Recommended screen
Usage Precautions
disconnection of
connectors
the cable after
connector coupling.
temperature profile
(Reference)
soldering conditions
(Reference)
thickness
1) To disconnect connectors, hook the end portion of E.FL-LP-N and U.FL-LP-N-2 onto the connector cover and pull off
1)
2) To couple the connectors, the coupling axes of both connectors are
After the connectors are coupled, do not apply a load to the cable in excess of the values indicated in the diagram
below.
Please note that excessive twisting in the action of insertion or removal will cause damage.
Recommended Temperature Profile (Reference)
1) The temperature indicates the printed circuit board surface temperature of the connector lead portion.
2) The reflow soldering method should be performed at a peak temperature of 240˚C or less at the surface of the
3) The temperature profile will change depending on conditions which include such factors as the size of the board,
Soldering iron temperature: 350˚C
Soldering time: Within 5 seconds
0.15 mm
vertically in the direction of the connector coupling axis.
To remove the connector directly, hold the connector cover and pull off
vertically in the direction of the connector coupling axis. (Please exercise
caution so as not to injure fingertips or nails.)
aligned and the connectors are inserted as perpendicularly as possible.
Do not attempt to insert on an extreme angle.
printed circuit board.
the solder used, and the solder thickness.
U.FL-LP-040
U.FL-R-SMT
2N or less
2N or less
4N or less
U.FL-LP-N-2
E.FL-LP-N
U.FL-R-SMT
U.FL-LP-040
U.FL-LP-066