SY3120 SMC, SY3120 Datasheet - Page 150

• Manufacturer Part Number: SY3120
• Description: 2 position single
• Manufacturer: SMC

DIN Rail Manifold Exploded View
Fig. (1) Block mounting procedure
1
2
3
4
How to Increase Manifold Bases
Loosen DIN rail holding screw
begins to turn idly. (While pressing DIN rail releasing buttons
at two locations, separate the manifold base from the DIN rail.)
Press manifold block assembly dividing button
location where manifold bases are to be added, until button
locks, and then separate the block assemblies.
Mount additional manifold block assembly on the DIN rail as
shown in the figure 1.
Press the block assemblies until a click sound is produced, and
tighten the DIN rail holding screw
(While lightly holding the blocks after fixing an end block on one
side, tighten the other end block for for better sealing.)
Caution (Tightening torque: 1.4 N·m)
Note 1) When there are 10 or fewer manifold block
Note 2) When disassembly and assembly are performed,
Caution
assemblies, and more are added to make a total of
11 or more, a supply/exhaust block assembly must
also be added.
air leakage may result if connections between
blocks and tightening of the end block’s holding
screw, is inadequate. Before supplying air, confirm
that there are no gaps, etc. between blocks, and
that manifold blocks are securely fastened to the
DIN rail. Then supply air and confirm that there is
no air leakage before operating.
Hook the DIN rail here and press down in
the direction of the arrow until a click
sound is heard.
a
fixing the manifold base until it
a
to fix them to the DIN rail.
Station expansion is possible at any position.
b
Base Mounted
, that are at the
c
b
,
Fitting Assembly Part No.
Metric size
Inch size
SY3000
SY5000
SY3000
SY5000
Series
How to Change Fitting Assembly
Note 1) P and R ports cannot be changed.
Note 2) Use caution that O-rings must be free from scratches and dust.
O-ring
One-touch fitting for ø
One-touch fitting for ø
One-touch fitting for ø
One-touch fitting for ø
One-touch fitting for ø
One-touch fitting for ø4
One-touch fitting for ø6
One-touch fitting for ø4
One-touch fitting for ø6
One-touch fitting for ø8
Otherwise, air leakage may result.
SY3000/5000
.
Clip
Fitting assembly
5 32
1 4
5 32
1 4
5 16
"
"
"
"
"
VVQ1000-50A-C4
VVQ1000-50A-C6
VVQ1000-51A-C4
VVQ1000-51A-C6
VVQ1000-51A-C8
VVQ1000-50A-N3
VVQ1000-50A-N7
VVQ1000-51A-N3
VVQ1000-51A-N7
VVQ1000-51A-N9
Type 45 manifold permits
change in the A and B port
sizes by changing the
manifold block fitting
assembly.
After removing the valve,
remove the clip with a
screwdriver, etc. For
mounting a new fitting
assembly, insert it and then
insert a clip until it will not
come out of the manifold
block.
Type
45
255
SJ
SY
SV
SYJ
SZ
VP4
S0700
VQ
VQ4
VQ5
VQC
VQZ
SQ
VFS
VFR
VQ7