CAT1021LI-30-T2 CATALYST [Catalyst Semiconductor], CAT1021LI-30-T2 Datasheet - Page 3
![no-image](/images/no-image-200.jpg)
CAT1021LI-30-T2
Manufacturer Part Number
CAT1021LI-30-T2
Description
Supervisory Circuits with I2C Serial 2k-bit CMOS EEPROM, Manual Reset and Watchdog Timer
Manufacturer
CATALYST [Catalyst Semiconductor]
Datasheet
1.CAT1021LI-30-T2.pdf
(21 pages)
PIN DESCRIPTION
RESET/RESET
(RESET CAT1021/23 Only)
These are open drain pins and RESET
as a manual reset trigger input. By forcing a reset
condition on the pin the device will initiate and
maintain a reset condition. The RESET pin must be
connected through a pull-down resistor, and the
¯¯¯¯¯¯ pin must be connected through a pull-up
RESET
resistor.
SDA: SERIAL DATA ADDRESS
The bidirectional serial data/address pin is used to
transfer all data into and out of the device. The SDA
pin is an open drain output and can be wire-ORed
with other open drain or open collector outputs.
SCL: SERIAL CLOCK
Serial clock input.
¯¯¯ : MANUAL RESET INPUT
Manual Reset input is a debounced input that can be
connected to an external source for Manual Reset.
Pulling the MR input low will generate a Reset
condition. Reset outputs are active while MR input is
low and for the reset timeout period after MR returns
to high. The input has an internal pull up resistor.
WP (CAT1021 Only): WRITE PROTECT INPUT
When WP input is tied to V
operations to the entire array are allowed. When tied
to V
internal pull down resistor.
WDI (CAT1023 Only): WATCHDOG TIMER INTERRUPT
Watchdog Timer Interrupt Input is used to reset the
watchdog timer. If a transition from high to low or low
to high does not occur every 1.6 seconds, the RESET
outputs will be driven active.
CAT102X FAMILY OVERVIEW
For supervisory circuits with embedded 16k EEPROM, please refer to the CAT1161, CAT1162 and CAT1163
data sheets.
© Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
MR
CAT1021
CAT1022
CAT1023
CAT1024
CAT1025
CAT1026
CAT1027
Device
CC
, the entire array is protected. This input has an
¯¯¯¯¯¯
Input Pin
Manual
Reset
: RESET OUTPUT
Watchdog
SS
or left unconnected write
¯¯¯¯¯¯ can be used
Watchdog
Monitor
SDA
SDA
WDI
WDI
Pin
Protection
Write
3
Pin
PIN FUNCTION
OPERATING TEMPERATURE RANGE
¯¯¯¯¯¯
RESET
RESET
Extended
Industrial
Name
SDA
SCL
WDI
V
WP
¯¯¯
Pin
NC
V
MR
CC
SS
Voltage Sense
Independent
Auxiliary
Function
No Connect
Active Low Reset Input/Output
Ground
Serial Data/Address
Clock Input
Active High Reset Output (CAT1021/23)
Power Supply
Write Protect (CAT1021 only)
Manual Reset Input
Watchdog Timer Interrupt (CAT1023)
-40ºC to 85ºC
-40ºC to 125ºC
CAT1021, CAT1022, CAT1023
Active High
and LOW
RESET:
Doc. No. MD-3009 Rev. M
EEPROM
2k
2k
2k
2k
2k
2k
2k