AT43USB355M-AC ATMEL [ATMEL Corporation], AT43USB355M-AC Datasheet - Page 91

• Manufacturer Part Number: AT43USB355M-AC
• Description: Full-speed USB Microcontroller with Embedded Hub, ADC and PWM
• Manufacturer: ATMEL [ATMEL Corporation]

Hub General Registers
2603G–USB–04/06
Global State Register – GLB_STATE
• Bit 7...5 – Reserved Bits
These bits are reserved in the AT43USB355 and will read as zeros.
• Bit 4 – SUSP FLG: Suspend Flag
This bit is set to 1 while the USB hardware is in the suspended state. This bit is a firmware
read only bit. It is set and cleared by the USB hardware.
• Bit 3 – RESUME FLGL Resume Flag
When the USB hardware receives a resume signal from the upstream device it sets this bit.
This bit will stay set until the USB hardware completes the downstream resume signaling. This
bit is a firmware read only bit. It is set and cleared by the USB hardware.
• Bit 2 – RMWUPE: Remote Wakeup Enable
This bit is set if the host enables the hub's remote wakeup feature.
• Bit 1 – CONFG: Configured
This bit is set by firmware after a valid SET_CONFIGURATION request is received. It is
cleared by a reset or by a SET_CONFIGURATION with a value of 0.
• Bit 0 – HADD EN: Hub Address Enabled
This bit is set by firmware after the status phase of a SET_ADDRESS request transaction so
the hub will use the new address starting at the next transaction.
Read/Write
Initial Value
$1FFB
Bit
R
7
–
0
R
6
–
0
R
5
–
0
SUSP FLG
R
4
0
RESUME FLG
R
3
0
RMWUPE
R/W
2
0
CONFG
AT43USB355
R/W
1
0
HADD EN
R/W
0
0
GLB_STATE
91