AT89C51RB2-RLTCM ATMEL [ATMEL Corporation], AT89C51RB2-RLTCM Datasheet - Page 85

• Manufacturer Part Number: AT89C51RB2-RLTCM
• Description: 8-bit Microcontroller with 16K/ 32K Bytes Flash
• Manufacturer: ATMEL [ATMEL Corporation]

Flash Registers and
Memory Map
Hardware Register
Flash Memory Lock Bits
4180B–8051–04/03
The AT89C51RB2/RC2 Flash memory uses several registers for its management:
•
•
The only hardware register of the AT89C51RB2/RC2 is called Hardware Security Byte
(HSB).
Table 65. Hardware Security Byte (HSB)
Boot Loader Jump Bit (BLJB)
One bit of the HSB, the BLJB bit, is used to force the boot address:
•
•
The three lock bits provide different levels of protection for the on-chip code and data,
when programmed as shown in Table 66.
Number
Bit
2-0
Hardware registers can only be accessed through the parallel programming modes
which are handled by the parallel programmer.
Software registers are in a special page of the Flash memory which can be
accessed through the API or with the parallel programming modes. This page,
called "Extra Flash Memory", is not in the internal Flash program memory
addressing space.
When this bit is set (programmed) value the boot address is 0000h.
When this bit is reset (unprogrammed) the boot address is F800h. By default, this bit
is reset and the ISP is enabled.
X2
7
6
5
4
3
7
Mnemonic
XRAM
LB2-0
BLJB
BLJB
Bit
X2
-
-
6
Description
X2 Mode
Programmed to force X2 mode (6 clocks per instruction) after reset.
Unprogrammed to force X1 mode, Standard Mode, after reset (Default).
Boot Loader Jump Bit
Unprogrammed this bit to start the user’s application on next reset at address
0000h.
Programmed this bit to start the boot loader at address F800h (Default).
Reserved
Reserved
XRAM Config Bit (only programmable by programmer tools)
Programmed to inhibit XRAM after reset.
Unprogrammed, this bit to valid XRAM after reset (Default).
User Memory Lock Bits (only programmable by programmer tools)
See Table 66.
5
-
4
-
XRAM
3
AT89C51RB2/RC2
LB2
2
LB1
1
LB0
0
85