AT24C02B ATMEL [ATMEL Corporation], AT24C02B Datasheet - Page 3

• Manufacturer Part Number: AT24C02B
• Description: Two-wire Serial EEPROM
• Manufacturer: ATMEL [ATMEL Corporation]

Pin Description
Memory Organization
5126B–SEEPR–10/05
SERIAL CLOCK (SCL): The SCL input is used to positive edge clock data into each
EEPROM device and negative edge clock data out of each device.
SERIAL DATA (SDA): The SDA pin is bidirectional for serial data transfer. This pin is
open-drain driven and may be wire-ORed with any number of other open-drain or open-
collector devices.
DEVICE/PAGE ADDRESSES (A2, A1, A0): The A2, A1 and A0 pins are device
address inputs that are hard wired for the AT24C02B. As many as eight 2K devices may
be addressed on a single bus system (device addressing is discussed in detail under
the Device Addressing section).
WRITE PROTECT (WP): The AT24C02B has a write protect pin that provides hardware
data protection. The write protect pin allows normal read/write operations when con-
nected to ground (GND). When the write protect pin is connected to V
protection feature is enabled and operates as shown in Table 2.
Table 2. Write Protect
AT24C02B, 2K SERIAL EEPROM: Internally organized with 32 pages of 8 bytes each,
the 2K requires an 8-bit data word address for random word addressing.
WP Pin
Status
At V
At GND
CC
Full (2K) Array
Normal Read/Write Operations
Part of the Array Protected
24C02B
AT24C02B
CC
, the write
3