M34D64-R STMICROELECTRONICS [STMicroelectronics], M34D64-R Datasheet - Page 6

• Manufacturer Part Number: M34D64-R
• Description: 64 Kbit Serial I2C Bus EEPROM With Hardware Write Control on Top Quarter of Memory
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

M34D64
Figure 7. Write Mode Sequences with WC=0 (data write enabled)
Write Operations
Following a Start condition the bus master sends
a Device Select Code with the RW bit reset to 0.
The device acknowledges this, as shown in Figure
7, and waits for two address bytes. The device re-
sponds to each address byte with an acknowledge
bit, and then waits for the data byte(s).
Writing to the memory may be inhibited if Write
Control (WC) is driven High. Any Write instruction
with Write Control (WC) driven High (during a pe-
riod of time from the Start condition until the end of
the two address bytes) will not modify the contents
of the top quarter of the memory.
Each data byte in the memory has a 16-bit (two
byte wide) address. The Most Significant Byte (Ta-
ble 3) is sent first, followed by the Least Significant
Byte (Table 4). Bits b15 to b0 form the address of
the byte in memory.
When the bus master generates a Stop condition
immediately after the Ack bit (in the “10
slot), either at the end of a Byte Write or a Page
6/21
WC
BYTE WRITE
WC
PAGE WRITE
WC (cont'd)
PAGE WRITE
(cont'd)
DEV SEL
DEV SEL
ACK
th
DATA IN N
bit” time
R/W
R/W
ACK
ACK
BYTE ADDR
BYTE ADDR
ACK
Write, the internal memory Write cycle is triggered.
A Stop condition at any other time slot does not
trigger the internal Write cycle.
During the internal Write cycle, Serial Data (SDA)
is disabled internally, and the device does not re-
spond to any requests.
Byte Write
After the Device Select code and the address
bytes, the bus master sends one data byte. If the
addressed location is Write-protected (top quarter
of the memory), by Write Control (WC) being driv-
en High, the location is not modified. The bus mas-
ter terminates the transfer by generating a Stop
condition, as shown in Figure 7.
Page Write
The Page Write mode allows up to 32 bytes to be
written in a single Write cycle, provided that they
are all located in the same ’row’ in the memory:
that is, the most significant memory address bits
(b12-b5) are the same. If more bytes are sent than
will fit up to the end of the row, a condition known
as ‘roll-over’ occurs. This should be avoided, as
ACK
ACK
BYTE ADDR
BYTE ADDR
ACK
ACK
DATA IN 1
DATA IN
ACK
ACK
DATA IN 2
AI01106C