HPC36004 NSC [National Semiconductor], HPC36004 Datasheet - Page 17

• Manufacturer Part Number: HPC36004
• Description: High-Performance microController
• Manufacturer: NSC [National Semiconductor]

HPC46064 Operating Modes
HPC46004 Operating Modes
EXPANDED ROMLESS MODE
Because the HPC46004 has no on-chip ROM it has only
one mode of operation the Expanded ROMless Mode The
EXM pin must be pulled high (logic ‘‘1’’) on power up the
EA bit in the PSW register should be set to a ‘‘1’’ The
HPC46004 is a ROMless device and is intended for use with
external memory The external memory may be any combi-
nation of ROM and RAM Up to 64k bytes of external mem-
ory may be accessed It is necessary to vector on reset to
an address between C000 and FFFF therefore the user
should have external memory at these addresses The EA
bit in the PSW register must immediately be set to ‘‘1’’ at the
beginning of the user’s program to disable illegal address
detection in the WATCHDOG logic
Note The on-chip RAM and Registers (0000 02FF) of the HPC46004 may
be accessed at all times
Wait States
The internal ROM can be accessed at the maximum operat-
ing frequency with one wait state With 0 wait states internal
ROM accesses are limited to
provides four software selectable Wait States that allow ac-
cess to slower memories The Wait States are selected by
the state of two bits in the PSW register Additionally the
RDY input may be used to extend the instruction cycle al-
lowing the user to interface with slow memories and periph-
erals
Expanded ROMless
Operating
Mode
TABLE II HPC46004 Operating Modes
EXM
Pin
1
EA
Bit
1
f
C
max The HPC46064
0300 FFFF off-chip
Configuration
Memory
FIGURE 17 16-Bit External Memory
(Continued)
17
Power Save Modes
Two power saving modes are available on the HPC46064
HALT and IDLE In the HALT mode all processor activities
are stopped In the IDLE mode the on-board oscillator and
timer T0 are active but all other processor activities are
stopped In either mode all on-board RAM registers and
I O are unaffected
HALT MODE
The HPC46064 is placed in the HALT mode under software
control by setting bits in the PSW All processor activities
including the clock and timers are stopped In the HALT
mode power requirements for the HPC46064 are minimal
and the applied voltage (V
altering the state of the machine There are two ways of
exiting the HALT mode via the RESET or the NMI The
RESET input reinitializes the processor Use of the NMI in-
put will generate a vectored interrupt and resume operation
from that point with no initialization The HALT mode can be
enabled or disabled by means of a control register HALT
enable To prevent accidental use of the HALT mode the
HALT enable register can be modified only once
IDLE MODE
The HPC46064 is placed in the IDLE mode through the
PSW In this mode all processor activity except the on-
board oscillator and Timer T0 is stopped As with the HALT
mode the processor is returned to full operation by the
RESET or NMI inputs but without waiting for oscillator stabi-
lization A timer T0 overflow will also cause the HPC46064
to resume normal operation
CC
) may be decreased without
TL DD 11372 – 15