LT3506 LINER [Linear Technology], LT3506 Datasheet - Page 5

• Manufacturer Part Number: LT3506
• Description: Dual Monolithic 1.6A Step-Down Switching Regulator
• Manufacturer: LINER [Linear Technology]

TYPICAL PERFOR A CE CHARACTERISTICS
PI FU CTIO S
BOOST1 (Pin 1), BOOST2 (Pin 8): The BOOST pins are
used to provide drive voltages, higher than the input
voltage, to the internal bipolar NPN power switches. Tie
through a diode from V
SW1 (Pin 2), SW2 (Pin 7): The SW pins are the outputs
of the internal power switches. Connect these pins to the
inductors, catch diodes and boost capacitors.
V
LT3506’s internal regulator and to the internal power
switch connected to SW1. These pins must be locally
bypassed.
V
nal power switch connected to SW2 and must be locally
bypassed. Connect these pins directly to V
for Channel 2 is coming from a different source.
RUN/SS1 (Pin 13), RUN/SS2 (Pin 12): The RUN/SS pins
are used to shut down the individual switching regula-
tors and the internal bias circuits. They also provide a
soft-start function. To shut down either regulator, pull the
RUN/SS pin to ground with an open drain or collector.
Tie a capacitor from these pins to ground to limit switch
current during start-up. If neither feature is used, leave
these pins unconnected.
IN1
IN2
U
(Pins 5, 6): The V
(Pins 3, 4): The V
U
3.0
2.5
2.0
1.5
1.0
0.5
0
–50
I
U
RUN/SS
IN2
OUT
–25
IN1
pins supply current to the inter-
vs Temperature
W
or from V
pins supply current to the
0
TEMPERATURE (°C)
25
U
50
IN
.
IN1
75
unless power
100
3506 G12
125
PG1 (Pin 14), PG2 (Pin 11): The Power Good pins are
the open collector outputs of an internal comparator. PG
remains low until the FB pin is within 10% of the final
regulation voltage. As well as indicating output regulation,
the PG pins can be used to sequence the two switching
regulators. These pins can be left unconnected. The PG
outputs are valid when V
of the RUN/SS pins is high. The PG comparators are
disabled in shutdown.
V
the internal error amps. The voltages on these pins control
the peak switch currents. These pins are normally used
to compensate the control loops, but can also be used to
override the loops. Pull these pins to ground with an open
drain to shut down each switching regulator.
FB1 (Pin 16), FB2 (Pin 9): The LT3506 regulates each
feedback pin to 800mV. Connect the feedback resistor
divider taps to these pins.
Exposed Pad (Pin 17): The Exposed Pad of the package
provides both electrical contact to ground and good thermal
contact to the printed circuit board. The Exposed Pad must
be soldered to the circuit board for proper operation.
C1
(Pin 15), V
1.4
1.2
1.0
0.8
0.6
0.4
0.2
0
–50
RUN/SS Thresholds vs
Temperature
–25
C2
(Pin 10): The V
0
TEMPERATURE (°C)
TO RUN
LT3506/LT3506A
25
IN
is greater than 3.4V and either
TO SWITCH
50
75
C
pins are the outputs of
100
3506 G13
125
3506afb