ATMEGA8U2_1 ATMEL [ATMEL Corporation], ATMEGA8U2_1 Datasheet - Page 18

no-image

ATMEGA8U2_1

Manufacturer Part Number
ATMEGA8U2_1
Description
8-bit Microcontroller with 8/16/32K Bytes of ISP Flash and USB Controller
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
10. Errata
10.1
10.1.1
10.2
10.2.1
10.3
10.3.1
7799CS–AVR–12/09
Errata ATmega8U2
Errata ATmega16U2
Errata ATmega32U2
rev. A and rev B
rev. A and rev B
rev. C
The revision letter in this section refers to the revision of the ATmega8U2 device.
• Full Swing oscillator
1. Full Swing oscillator
The revision letter in this section refers to the revision of the ATmega16U2 device.
• Full Swing oscillator
1. Full Swing oscillator
The revision letter in this section refers to the revision of the ATmega32U2 device.
No Known Errata
The maximum frequency for the Full Swing Crystal Oscillator is 8MHz. For Crystal frequen-
cies > 8MHz the Full Swing Crystal Oscillator is not guaranteed to operate correctly.
Problem fix/Workaround
If a Crystal with frequency > 8MHz is used, the Low Power Crystal Oscillator option should
be used instead. See table 8-1 for an overview of the Device Clocking Options. Note that the
Low Power Crystal Oscillator will not provide full rail-to-rail swing on the XTAL2 pin. If sys-
tem clock output is needed to drive other clock inputs while running from the Low Power
Crystal Oscillator, the system clock can be output on PORTC7 by programming the CKOUT
fuse.
The maximum frequency for the Full Swing Crystal Oscillator is 8MHz. For Crystal frequen-
cies > 8MHz the Full Swing Crystal Oscillator is not guaranteed to operate correctly.
Problem fix/Workaround
If a Crystal with frequency > 8MHz is used, the Low Power Crystal Oscillator option should
be used instead. See table 8-1 for an overview of the Device Clocking Options. Note that the
Low Power Crystal Oscillator will not provide full rail-to-rail swing on the XTAL2 pin. If sys-
tem clock output is needed to drive other clock inputs while running from the Low Power
Crystal Oscillator, the system clock can be output on PORTC7 by programming the CKOUT
fuse.
ATmega8U2/16U2/32U2
18

Related parts for ATMEGA8U2_1