WM9711_06 WOLFSON [Wolfson Microelectronics plc], WM9711_06 Datasheet - Page 45

• Manufacturer Part Number: WM9711_06
• Description: Low Power Audio CODEC for Portable Applications
• Manufacturer: WOLFSON [Wolfson Microelectronics plc]

Production Data
w
LOW POWER STANDBY MODE
If all the bits in registers 26h and 24h are set, then the WM9711L is in low-power standby mode and
consumes very little current. A 1MΩ resistor string remains connected across AVDD to generate
VREF. This is necessary if the on-chip analogue comparators are used (see “Battery Alarm” section),
and helps shorten the delay between wake-up and playback readiness. If VREF is not required, the
1MΩ resistor string can be disabled by setting the SVD bit, reducing current consumption further.
Table 33 Disabling VREF (for lowest possible power consumption)
SAVING POWER AT LOW SUPPLY VOLTAGES
The analogue supplies to the WM9711L can run from 1.8V to 3.6V. By default, all analogue circuitry
on the IC is optimized to run at 3.3V. This set-up is also good for all other supply voltages down to
1.8V. However, at lower voltages, it is possible to save power by reducing the internal bias currents
used in the analogue circuitry. This is controlled as shown below.
Table 34 Analogue Bias Selection
58h
5Ch
REGISTER
REGISTER
ADDRESS
ADDRESS
10
6:5
BIT
BIT
SVD
V[1:0]
LABEL
LABEL
0
11
DEFAULT
DEFAULT
VREF Disable
0: VREF enabled using 1MΩ string (low-power
standby mode)
1 : VREF disabled, 1MΩ string disconnected
(OFF mode)
Analogue Bias optimization
11 : Lowest bias current, optimized for 1.8V
10 : Low bias current, optimized for 2.5V
01, 00 : Default bias current, optimized for 3.3V
DESCRIPTION
DESCRIPTION
PD Rev 4.3 August 2006
WM9711L
45