ATTIny2313-16MI ATMEL Corporation, ATTIny2313-16MI Datasheet - Page 18

• Manufacturer Part Number: ATTIny2313-16MI
• Description: 8-bit AVR Microcontroller with 2K Bytes In-System Programmable Flash
• Manufacturer: ATMEL Corporation

Atomic Byte Programming
Split Byte Programming
18
ATtiny2313/V
Table 1. EEPROM Mode Bits
• Bit 3 – EERIE: EEPROM Ready Interrupt Enable
Writing EERIE to one enables the EEPROM Ready Interrupt if the I-bit in SREG is set.
Writing EERIE to zero disables the interrupt. The EEPROM Ready Interrupt generates a
constant interrupt when Non-volatile memory is ready for programming.
• Bit 2 – EEMPE: EEPROM Master Program Enable
The EEMPE bit determines whether writing EEPE to one will have effect or not.
When EEMPE is set, setting EEPE within four clock cycles will program the EEPROM at
the selected address. If EEMPE is zero, setting EEPE will have no effect. When EEMPE
has been written to one by software, hardware clears the bit to zero after four clock
cycles.
• Bit 1 – EEPE: EEPROM Program Enable
The EEPROM Program Enable Signal EEPE is the programming enable signal to the
EEPROM. When EEPE is written, the EEPROM will be programmed according to the
EEPMn bits setting. The EEMPE bit must be written to one before a logical one is writ-
ten to EEPE, otherwise no EEPROM write takes place. When the write access time has
elapsed, the EEPE bit is cleared by hardware. When EEPE has been set, the CPU is
halted for two cycles before the next instruction is executed.
• Bit 0 – EERE: EEPROM Read Enable
The EEPROM Read Enable Signal – EERE – is the read strobe to the EEPROM. When
the correct address is set up in the EEAR Register, the EERE bit must be written to one
to trigger the EEPROM read. The EEPROM read access takes one instruction, and the
requested data is available immediately. When the EEPROM is read, the CPU is halted
for four cycles before the next instruction is executed. The user should poll the EEPE bit
before starting the read operation. If a write operation is in progress, it is neither possible
to read the EEPROM, nor to change the EEAR Register.
Using Atomic Byte Programming is the simplest mode. When writing a byte to the
EEPROM, the user must write the address into the EEAR Register and data into EEDR
Register. If the EEPMn bits are zero, writing EEPE (within four cycles after EEMPE is
written) will trigger the erase/write operation. Both the erase and write cycle are done in
one operation and the total programming time is given in Table 1. The EEPE bit remains
set until the erase and write operations are completed. While the device is busy with
programming, it is not possible to do any other EEPROM operations.
It is possible to split the erase and write cycle in two different operations. This may be
useful if the system requires short access time for some limited period of time (typically
if the power supply voltage falls). In order to take advantage of this method, it is required
that the locations to be written have been erased before the write operation. But since
the erase and write operations are split, it is possible to do the erase operations when
the system allows doing time-consuming operations (typically after Power-up).
EEPM1
0
1
1
EEPM0
1
0
1
Programming
1.8 ms
1.8 ms
Time
–
Operation
Erase Only
Write Only
Reserved for future use
2543C–AVR–12/03