CDM-20210 ETC, CDM-20210 Datasheet - Page 17
![no-image](/images/no-image-200.jpg)
CDM-20210
Manufacturer Part Number
CDM-20210
Description
LCD component
Manufacturer
ETC
Datasheet
1.CDM-20210.pdf
(17 pages)
Storage
Cleaning
Others:
•
•
•
•
•
•
•
•
•
•
•
To prevent destruction of the elements by static electricity, be careful to maintain an optimum work environment.
When storing the LCD modules, avoid exposure to direct sunlight or to the light of fluorescent lamps
Store the module in a dark place where the temperature is 25
Do not store the module near organic solvents or corrosive gases.
Do not crush, shake, or jolt the module (including accessories).
Do not wipe the polarizing plate with a dry cloth, as it may scratch the surface.
Wipe the module gently with soft cloth soaked with a petroleum benzene.
Do not use ketonic solvents (ketone and acetone) or aromatic solvents (toluene and xylene), as they may damage the
polarizing plate.
Liquid crystals solidify under low temperature (below the storage temperature range) leading to defective orientation
or the generation of air bubbles (black or white). Air bubbles may also be generated if the module is subject to a low
temperature.
If the LCD modules have been operating for a long time showing the same display patterns, the display patterns may
remain on the screen as ghost images and a slight contrast irregularity may also appear. A normal operating status can
be regained by suspending use for some time. It should be noted that this phenomenon does not adversely affect
performance reliability.
To minimize the performance degradation of the LCD modules resulting from destruction caused by static electricity
etc., exercise care to avoid holding the following sections when handling the modules.
PACIFIC DISPLAY DEVICES
o
o
o
o
-
-
Be sure to ground the body when handling the LCD modules.
Tools required for assembling, such as soldering irons, must be properly grounded.
To reduce the amount of static electricity generated, do not conduct assembling and other work under dry
conditions.
The LCD module is coated with a film to protect the display surface. Exercise care when peeling off this
protective film since static electricity may be generated.
Exposed area of the printed circuit board.
Terminal electrode sections.
04.11.2003
o
C ±10
o
C and the humidity below 65% RH.
17