LDH54xxxx Murata Manufacturing, LDH54xxxx Datasheet - Page 9

• Manufacturer Part Number: LDH54xxxx
• Description: (LDH Series) Chip Multilayer Delay Lines
• Manufacturer: Murata Manufacturing

!Note
!Note
1. Cleaning Conditions:
Notice (Other)
The total cleaning time of soaking, ultrasonic and steam
methods should be within 5 minutes.
Consult with Murata concerning the cleaning solvent. In
order to totally abolish ODC (Freon, Trichrolethan),
Murata has carried out testing on non-cleaning and
water-cleaning solvents (water-soluble flux, water-soluble
cream solder, water-based cleaning solvent). Therefore,
be sure to contact Murata beforehand for details when
applying any of the above mentioned cleaning fluids.
The ultrasonic cleaning conditions are indicated below :
If the ultrasonic output power is too high, the PCB may
resonate and products mounted on the PCB may be
damaged. The ultrasonic cleaning conditions may
change depending on the size of the vessel and the size
of the PCB. Contact Murata regarding conditions other
than those stated above.
Be sure to completely dry products immediately after
cleaning.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this PDF catalog to prevent smoking and/or burning, etc.
This catalog has only typical specifications. Therefore, you are requested to approve our product specifications or to transact the approval sheet for product specificaions before ordering.
Temperature
Frequency
Power
20 W per liter max.
40 deg.C max.
50 - 60 kHz
2. Operational Environment Conditions:
If products could be used under the preceding conditions,
consult with Murata before actual use. Be sure to
completely dry products immediately after cleaning.
Products are designed to work for electronic products
under normal environmental conditions (ambient
temperature, humidity and pressure). However, if
products are used under the following circumstances, it
may damage products and leakage of electricity and
abnormal temperature may occur.
- In an atmosphere containing corrosive gas ( Cl
- In an atmosphere containing combustible and volatile
- Dusty conditions
- Direct sunlight
- Wet conditions
- High humidity locations
- Freezing conditions
SO
gases
x
, NO
x
etc.)
N91E7.pdf 03.5.13
Notice
2
, NH
3
9
,
1